VS indicators not working

[VSCHASE]

Hey, the title explains my problem the indicators decided to stop working, for what reason i dont know, but i sussed out the fuse even tho it runs off the same fuse as the wipers and they are all ok. So i checked the relay, also all ok, i have no idea why it would just stop working, the high beam works on the stalk just not the indicators. So any ideas or knowledge would be much appreciated!

[hako]

Try pressing the hazard button a few times - if this plays up it kills the flashers. This is a common problem.

[Dum*P*ster]

Hi bud

If you press you're Hazard Light button, will the indicators work?
On the Relay, are the 'prongs' burnt out ?
When you try to indicat Left or Right do you hear any Clicking sounds to know if its working, but with no lights?

It's possible that the wires behind the fuse board may have burnt out for the indicators, (doubt it tho)
You might have a bad wire somewhere thats shorting out,
If you have a Towbar, you most likely will have the Trailer Harness for it.. A lot of issues is caused by it, over time it gets old and shits out..And causes problems.. Like mine did LOL

[knight wombat]

had the same problem with a mates vr crawled all over it for days ended up be a faulty hazard switch

[VSCHASE]

hey guys,

i tried the hazard button nothing works there either, i checked the wires behind the stalk nothings burnout or anything, the prongs on the relay are fine, i even chucked a new one in just to see and still nothing. yeah ill just have to start tracing wires i guess

[VSCHASE]

i might replace the hazard switch then see if that makes a difference

[Dum*P*ster]

i might replace the hazard switch then see if that makes a difference

Better yet, unplug it.. And see if the indicators will work

[VSCHASE]

just did and it did nothing

[RX25SE]

Better yet, unplug it.. And see if the indicators will work

just did and it did nothing

That's because the indicators are wired through the hazard switch.


Did you try another flasher can? (looks like a relay)

[Dum*P*ster]

Ahh not good,

The main places I firstly look for faulty wires.. is in the rear, go from the the taillight wires to the loom plug, and see if the plug is rooted or causing issues.

[Dum*P*ster]

That's because the indicators are wired through the hazard switch.

Ahh, didnt know! Learning new things everyday,
so advice now is, grab a new button when you can

[VSCHASE]

That's because the indicators are wired through the hazard switch.


Did you try another flasher can? (looks like a relay)

flasher can? i tried another relay but not a flasher can

[James39]

Maybe replace the indicator stalk? If that breaks the hazard lights will not work as far as I know...

[RX25SE]

flasher can? i tried another relay but not a flasher can

Maybe the same thing?

It's the thing that makes the (causes the on/off action) clicking sound when the indicators flash.