Results 1 to 9 of 9

Thread: cam angle

  1. #1
    aussie4life11's Avatar
    aussie4life11 is offline backyard argument starter
    Ride
    94 vr 3.8l v6 Auto Series 2 Acclaim

    Join Date
    Oct 2011
    Location
    Geraldton, Western Australia
    Posts
    678

    Default cam angle

    HEy guys can anyone tell me where the cam angle sensor is and if its different from the crank angle sensor

  2. #2
    Ride
    few commodores

    Join Date
    Feb 2011
    Location
    victoria
    Posts
    1,199

    Default

    crank angle sensor: behind the harmonic balancer controls your ignition timing
    cam angle/position/phase sensor: in the timing cover basically next to the water pump, tells the ecu where the cam is and what injectors it should be pulsing

  3. #3
    aussie4life11's Avatar
    aussie4life11 is offline backyard argument starter
    Ride
    94 vr 3.8l v6 Auto Series 2 Acclaim

    Join Date
    Oct 2011
    Location
    Geraldton, Western Australia
    Posts
    678

    Default

    any chance of a picture of it mate? i think i may hace found it but im not sure.

    is this it? the one on the right was in my car with the bolt holding it in looser than finger tight.

    and the mark down the centre of the right one is my fingernail drag mark. the left one is outa the wrecker
    Attached Thumbnails Attached Thumbnails cam angle-img_0001.jpg  

  4. #4
    Ride
    few commodores

    Join Date
    Feb 2011
    Location
    victoria
    Posts
    1,199

    Default

    yeah that looks like it, guessing you have a problem with it?

    Sometimes it's not the sensor playing up but the magnet on the camshaft timing gear that the sensor read has broken and fallen off, turn the engine over by hand (spanner on the hb bolt) and watch inside the hole that came out of to make sure it's still there.

  5. #5
    aussie4life11's Avatar
    aussie4life11 is offline backyard argument starter
    Ride
    94 vr 3.8l v6 Auto Series 2 Acclaim

    Join Date
    Oct 2011
    Location
    Geraldton, Western Australia
    Posts
    678

    Default

    i just seen what brett_jjj said about it on another post and it made sense to me. my car runs fine high up in the revs while im driving but the idle is very erratic. sounds like its missing but all the coil packs are working and all the injecters are to. and its not isolated to any one cylinder

  6. #6
    James39's Avatar
    James39 is offline Gave up on VL's
    Ride
    1995 VS Acclaim & 1992 Holden Barina

    Join Date
    Jul 2009
    Location
    Newcastle NSW
    Posts
    876

  7. #7
    aussie4life11's Avatar
    aussie4life11 is offline backyard argument starter
    Ride
    94 vr 3.8l v6 Auto Series 2 Acclaim

    Join Date
    Oct 2011
    Location
    Geraldton, Western Australia
    Posts
    678

    Default

    nope i get 33 44 45 and 47 all the time. but sometimes things dont throw a code. and its worthwile replacing it anyway as you saw how dirty it was

  8. #8
    Ride
    few commodores

    Join Date
    Feb 2011
    Location
    victoria
    Posts
    1,199

    Default

    i'd be looking at 33, map sensor high voltage, could be causing the o2 rich/lean probs and the idle issue if your map is faulty.

    47 yes cas or dfi can cause this. not probs with the cam angle sensor

    the build up on it wouldn't worry it, all it does is sense a strong magnet going past and all the internals are well protected.

  9. #9
    aussie4life11's Avatar
    aussie4life11 is offline backyard argument starter
    Ride
    94 vr 3.8l v6 Auto Series 2 Acclaim

    Join Date
    Oct 2011
    Location
    Geraldton, Western Australia
    Posts
    678

    Default

    yea. swapped map, swapped o2. lean rich gone for now.i know the cas is on its way out as it only throws that code every now and again so its just dropping out then coming back i reckon

Similar Threads

  1. HMM crank angle or not
    By 38VNIT in forum VN - VP Holden Commodore (1988 - 1993)
    Replies: 7
    Last Post: 04-07-2009, 07:43 AM
  2. wheel angle.... /--\ help anyone??
    By PaRaDoX in forum VN - VP Holden Commodore (1988 - 1993)
    Replies: 4
    Last Post: 29-01-2006, 11:42 PM
  3. right angle RCAs
    By jack.mc in forum Car Audio
    Replies: 10
    Last Post: 30-11-2005, 02:04 PM
  4. Cam Angle Sensor?
    By fitzy2005 in forum VR - VS Holden Commodore (1993 - 1997)
    Replies: 5
    Last Post: 18-10-2005, 06:49 AM
  5. Sub box angle
    By matty88 in forum Car Audio
    Replies: 10
    Last Post: 29-08-2005, 09:40 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72