Stereo change over

[wokky]

hey people just after the simplest way to remove a genuine stereo from a vs acclaim and also a vn any advice would be greatly appreciated.

 

[sircruisealotVS]

have a look at some of the threads in the audio section and in the how-to section...that should tell you everything you need to know champ

 

[kopper69]

Yea theres only one way to take the head unit out and thats pulling out the dash. No real drama.

 

[markovr]

Pulling out the dash means console, glove box and associated trim ,panel under column, centre shroud ,centre switch/flashing led assembly and heater controls.
To get a factory fitted look use the brackets off you stocko radio and put them on to the new unit by measuring where they sit on the old one and put them on the new one in the same posy.You might have to drill new holes in the bracket to fit the new units mounting holes.
Then it fits straight in and looks good and uses all original mounts.Space at the back is limited so some repositioning where the wires sit may have to be done so the unit pushes in flush. 90 degree rca type plugs at the back of the radio definately make it easier if you are putting a amp in.

 

[kopper69]

There is no need to remove the passenger side glove box. There are only about 10 screws in total to take out.

 

[Lumps of cheese]

There is no need to remove the passenger side glove box. There are only about 10 screws in total to take out.

Very true, should be no need to remove your dash, i'm sure i saw a thread on this somewhere in here...... :thumbsup: