Welcome to Just Commodores, a site specifically designed for all people who share the same passion as yourself.
Computer Reset
- Thread starter onsta004
- Start date
M
medz84
Guest
i need to do the same ive been told t ohold at 3 grand for a certaint period of time i cant do that because my cars a little to loud in the neibourhood also if you disconnect the battery for a while not sure id like to know too
mattman
New Member
- Joined
- Dec 12, 2005
- Messages
- 2,305
- Reaction score
- 13
- Points
- 0
- Location
- Brisbane
- Members Ride
- '00 WH V6
Disconnect the battery and hold the brake pedal on fully for about 1 min... leave it unhooked for about half an hour "just to be sure" and you should be good to go... it might take a couple hundred k's to relearn but you should be runnin sweet after first refill.
Cheap6
New Member
- Joined
- Jun 19, 2005
- Messages
- 2,498
- Reaction score
- 74
- Points
- 0
- Members Ride
- VP Exec
Removing and replacing the EFI fusible link, under the bonnet near the relay box, will restore the ECM to the (factory?) programmed default values.
onsta004 you didn't say but the ECM should have been/should be reprogrammed to suit the new engine.
onsta004 you didn't say but the ECM should have been/should be reprogrammed to suit the new engine.
CHANDLC
BushBasher
- Joined
- Mar 31, 2006
- Messages
- 218
- Reaction score
- 0
- Points
- 0
- Location
- TOWNSVILLE
- Members Ride
- 1996 V6 VS LEXCEN
pull out engine fuse leave out for aprox 1 min then replace and all should be well thats if it is a VS
clinster73
New Member
- Joined
- Sep 1, 2004
- Messages
- 144
- Reaction score
- 0
- Points
- 0
- Age
- 50
- Location
- Adelaide
- Members Ride
- VS Berlina S2
mattman said:
whats the go with holding the brake pedal down?
clinster73
New Member
- Joined
- Sep 1, 2004
- Messages
- 144
- Reaction score
- 0
- Points
- 0
- Age
- 50
- Location
- Adelaide
- Members Ride
- VS Berlina S2
I tried puling out the engine fuse to reset it and i dont think it did!?
I think i may have to disconnect the battery....
I think i may have to disconnect the battery....
bobmat111
New Member
- Joined
- Apr 26, 2010
- Messages
- 27
- Reaction score
- 1
- Points
- 0
- Location
- Adelaide. South Australia.
- Members Ride
- Commodore 1988 VN Calais S1 V6
I was told by a Holden dealer that all you have to do to reset
the computer is to disconect the battery for a few minutes then
reconnect the battery and then take your car for a quiet drive
for five kms.
Then after this your computer is now reset and you can
drive your car the way that you normally drive it.
I have done this many times on mine and my wifes cars
and it has worked.
I hope that this has helped you.
Cheers.
Bob...
bobmat111.
the computer is to disconect the battery for a few minutes then
reconnect the battery and then take your car for a quiet drive
for five kms.
Then after this your computer is now reset and you can
drive your car the way that you normally drive it.
I have done this many times on mine and my wifes cars
and it has worked.
I hope that this has helped you.
Cheers.
Bob...
bobmat111.