how 2 change crank angle sensor ?

[muzza]

hi guys i have a 97 vs v6 and i need to find out xactly how to change the crank angle sensor i searched the how to s but i cannot find anything any help is appreicated cheers muz ps i found these on ebay any1 no if theyd b cheep junk or ok thanks http://cgi.ebay.com.au/Holden-VP-VR...ryZ33612QQssPageNameZWDVWQQrdZ1QQcmdZViewItem

 

[vsiicalais]

in regards to the quality of that specific CAS im not sure on that one, i know i got mine from holden for about the same price.

i have got a very brief description from the gregory's manual, remove crankshaft pulley, disconnect the wiring from CAS, insert screwdriver behind the shield adjacent to retaining studs and lever shield from timing cover gently, remove retaining bolts and remove CAS, check the interrupter blades at rear of crankshaft pulley for damage (if damaged replace) reassemble and apply locktite to retaining bolts.

 

[muzza]

thanks for the info m8 ill give it a try cheers

 

[Immortality]

you'll need a puller to get the balancer of the crankshaft. yuo'll also need a 24mm socket (i think) with a decent breaker bar to get the balancer retaining bolt undone

 

[Zuicider]

a rattle gun and a stolen hydraulic puller does the job

 

[LowVp]

also check that the air gap on the cas matches the gaps on the balancer else you will be doing it again

 

[muzza]

do i need to goto the trouble of pulling the radiator off to get the balancer off guys ?

 

[DannyboyDS]

at least remove the thermo fan..