VT Extractors

[6 shooter]

Will Vt extractors fit onto a manual vr with a vt l67 engine put into it?

[DannyboyDS]

thats a good question,

I'm not 100% sure but heres a few guesses, keep in mind these are only guesses.

Ecotec engines have equal spacing between the exhaust outlets on the side of the engine, the VT has an ecotec in it if it is a 6

The L67 is very similar to the ecotec in many ways, however then again it is also VERY, very different, but i'll GUESS that this is a point that is the same.

The L67 has an auto or manual fitted to it? as this is what I think will stuff you up.

I hope my guesses havn't offended anyone with more knowledge then myself.

[6 shooter]

yea im just wanting to know if theyll fit in between the power steering rack and in the engine bay before i go out and buy some and find out they dont fit its going to have a manual in it

[ephect]

short answer is, not without modificaion..

what your best bet is, grab some VS supercharged extractors, which
a) will bolt up to the VT sc engine, same engine as VS sc
b) will fit in the engine bay without a problem. unlike the VT engine bay, which has a little more room.

[Not_An_Abba_Fan]

VT extractors will not go around the rack in the VR, so no, they will not fit. Use VS ones as the engine is the same.