Results 1 to 3 of 3

Thread: Power steering hoses

  1. #1
    Ride
    VS Caprice SII

    Join Date
    Mar 2007
    Location
    Northern Suburbs
    Posts
    98

    Default Power steering hoses

    im wanna change my power steering hoses tomorrow cause they look really shitty. just wondering if theres any precautions to take. do i have to make sure i dont get any air in the system?

  2. #2
    Ride
    MY08 Subaru Liberty GT-B & VS Exec

    Join Date
    Dec 2005
    Location
    Glen Waverley VIC
    Posts
    1,024

    Default

    Quote Originally Posted by greenvs View Post
    im wanna change my power steering hoses tomorrow cause they look really shitty. just wondering if theres any precautions to take. do i have to make sure i dont get any air in the system?
    Just make sure that you have a big enough container to drain the fluid into. I'd recommend using new fluid too, and throughly clean out the reservoir and strainer whilst you are at it, and make sure that no grease, dirt etc gets into the lines when you disconnect them. To bleed the system, make sure that the front of the car is off the ground, fill up the reservoir to max and then WITHOUT the engine running, turn the steering wheel lock to lock several times until the level in the reservoir goes down, and you stop seeing bubbles. If you need to top up the reservoir do so and then continue going lock to lock. Once this is done the system should be bleed, and you can start the engine and let it idle, once the fluid has been pumped around, I'd recommend going lock to lock again just to be sure.

  3. #3
    ephect's Avatar
    ephect is offline Donating Member
    Ride
    VS Acclaim V6

    Join Date
    Jul 2006
    Location
    Melbourne
    Posts
    3,271

    Default

    just take note of which goes where obviously, and be sure to use quality new hoses

    but Harvs82 has it down pat
    ------------------------------------------------------
    ------------------------------------------------------

    Quote Originally Posted by JEZIMP View Post
    jsut quickly, wat is a ffs search, ive seen it a fair bit and not sure wat it is, so some help would b greatly appreciated on where and how to do it, thankz
    Quote Originally Posted by vcstarfirequeen View Post
    its a 5 stud and u couldnt just weld a new stud on youd have to weld 5 new ones on i may be blonde but im not dumb

    Wanted: VR/VS Standard Rear Bumper Bar - Can be damaged - PM me if you have one

Similar Threads

  1. Replies: 1
    Last Post: 09-11-2008, 09:18 AM
  2. reminder about the power steer hoses
    By Torquative in forum VZ Holden Commodore (2004 - 2006)
    Replies: 0
    Last Post: 20-10-2008, 08:19 PM
  3. power stearing hoses
    By maxpower QLD in forum VL Holden Commodore (1986 - 1988)
    Replies: 3
    Last Post: 09-09-2008, 06:35 PM
  4. oil line from power steering to steering rack
    By onmy6 in forum VT - VX Holden Commodore (1997 - 2002)
    Replies: 0
    Last Post: 14-12-2007, 10:08 AM
  5. VH Power Steering..Trade For Manual Steering
    By vasrox in forum Swap / Wanted to Buy / Trade
    Replies: 1
    Last Post: 28-01-2007, 02:29 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72