Help wanted

[Lonewolf]

Hi all how hard is it to put new engine mounts in vt with out pulling motor out and does anybody have anyspare?

[Sabbath']

It'd be a major pain in the arse to do them without a hoist. But probably do-able.

[Lonewolf]

so if i had a hoist should be fine does motor need to come out

[wana s' charge stock vt]

its not that hard, the one on air con side is a bit of a hassle, you need to unbolt air con from block and move it aside to get in there. i just supported the motor with a jack and timber across the sump and did one side at a time, might need to lift motor 5-10mm to take weight off n line up bolt holes. but pretty simple, just fiddly. and new ones are only $50ish from supercheap ect

oop's, just seen yours is a gtr

[Lonewolf]

Thanks mate cheers for the help guys

[accentstencil]

its not that hard, the one on air con side is a bit of a hassle, you need to unbolt air con from block and move it aside to get in there. i just supported the motor with a jack and timber across the sump and did one side at a time, might need to lift motor 5-10mm to take weight off n line up bolt holes. but pretty simple, just fiddly. and new ones are only $50ish from supercheap ect

oop's, just seen yours is a gtr

I did mine the same way, it was a little difficult but I got it done.