This could help...
2.15 REAR LAMP ASSEMBLY — SEDAN
REAR QUARTER LAMP ASSEMBLY
REMOVE
1. Open rear compartment.
2. Remove rear quarter lamp assembly to body
attaching screws, refer to Fig.12B-30.
3. Pull rear quarter lamp housing sideways out from
panel so that locating peg on side of lamp assembly
snaps free from retainer.
4. While supporting lamp housing, remove back-up
light bulb socket, turn signal bulb socket and
stop/tail light bulb socket by turning socket
anti-clockwise and removing.
REINSTALL
1. Insert bulb sockets into rear quarter lamp housing,
ensuring sockets are correctly located and lock
securely into place.
2. Ensure that rear quarter lamp harness grommet is
seated correctly. Assemble lamp housing to body,
ensuring locating peg snaps into retainer and install
and tighten attaching screws to the correct torque
specification.
REAR QUARTER LAMP HOUSING TO
BODY ATTACHING SCREW
TORQUE SPECIFICATION
1 – 3 Nm
3. Check rear lamp operation.