VT Warning Lights ,Starter, Window message

[Davidcurley]

I am having problems with my vt V6 First All the warning light came on, Then I was receving a service error message, Then the starter would not operate. Now The starter sometimes operates and the egine fires but will not run. Can anyone help Please

[accentstencil]

Is the security light in the mode switch flashing while you are trying to start it?

[Davidcurley]

No security light not flashing when trying to start but sometimes engine stars, Occassional serv error in windoow

[PRAVX II S]

First of all check for fault codes.
For all the warning lights coming on it could be the ABS module if fitted

[Davidcurley]

Thanks but dont have fault scanner. Suspect ABS module but because of cost need to find a way to Isolate that. What is cost of scanner and where can I obtain one?

[kaz777cars]

would any one know where and how to pull or disconnect out the warning beeper for the handbrake?

[accentstencil]

Thanks but dont have fault scanner. Suspect ABS module but because of cost need to find a way to Isolate that. What is cost of scanner and where can I obtain one?

You can check the codes without a scanner simply by following the instructions in this link: Checking error codes VT/VX

[PRAVX II S]

Thanks but dont have fault scanner. Suspect ABS module but because of cost need to find a way to Isolate that. What is cost of scanner and where can I obtain one?

you dont need a scanner just bridge pins 5&6 on the diagnostic located under the drivers side dash. Search the forum. seek and you shall find.
could be a lot of things making your car not start.
Inhibitor switch if auto,CAS,Factory security,Relays,PCM, and so on.