wheelbearing ABS light

[madsav]

Hi guys, vt with ABS.
Just replaced the front wheelings pluged the abs wiring back in now the ABS light is staying on. Any help if possable please and no i didnt disconnect the battery when i did the job would this mean i have to take it to holden to get it cleared?

[BlackVXGTS]

I'd say that the ABS connectors haven't been fitted correctly. I know that when I replaced my hubs, one connector fitted easily but the other was a real ba..ard to fit properly. Make sure the male connectors on the mub haven't been bent. Alternatively you could try and bridge pins 5 and 12 of the OBD connector and see what error codes you get.

[madsav]

will it still show up even thou its a ls1? i was told that bridging the wires wont work on the ls1 , as for the connecters i pulled it all apart again unpluged them had a look to make sure no pins were bent everything seems ok. im about 5min from throwing spanners at the car lol

[madsav]

Just discovered,when the car is cold take it for a drive NO ABS LIGHT comes on. after the car warms up the light comes on AGAIN . is it possable that 1 of the wheel bearings are faulty?

[madsav]

After messing around and breaking afew things found the problem, the passenger side Wheel bearing ABS sensor must be stuffed .Pluged the old ones in and the light went off pluged the new 1 in light comes on. is there any way to swap my old ABS sensor t othe new 1 or do i need to order another Wheelbearing hub?