Hey all, I have a series 1 VX Commodore, when I go over a large bump "speed hump" or pull into my driveway there is a small knock coming from the front of the car. It sounds to me like its coming from the left side front.
Any ideas what this is? Should I fix it myself or get a professional to do so ?
hey there. it could be your engine mounts, or your front chassis moving around abit. does this sound go away after you exit the speed hump?
Yeah when the car is going in a straight line there are no sounds at all, just when the car is turning while is going over something "drive way" or "speed bump"
yea get it checked out by ur mechanic. hows the feel of the car on the freeway? is it smooth or is their vibration?
Yeah fine on the freeway, when its sitting on 90-100, no worries but when i get to 100-115 she starts to shake abit. it does need a wheel alignment, it could be just that perhaps
Link pin bushes? is that the stabaliser bar ?
its the pin that links the stabliser bar with the front wheels, turn ur wheels full lock to one side and you can see them.
Yeah I just did that........but im not sure what im looking at, what i can see it abit of rubber where the pinlink is, and its all squashed
well you just answered your question. its your link bushes. check the " D " bushes aswell. (open bonnet and look between fans and engine. there are 2 bushes that connect the swaybar to the crossmember. )you can replace just the bushes but your pins could be bent aswell so replace them both sides at a time
96 EF2 Futura I6 Auto SedanSuperlows Front/Rear with Monroe GT Sport's, EL XR Front, 16" Tickford Wheels with 225/50 Wanlis
, 5% Tint, Sony Headunit/ 6 1/2" 190w Speaker's, Fram Air Filter/XR6T Snorkle, Pacemaker 4499's/Hi Flow Cat/2.5 inch Redback, 4.11's/LSD
15.37 @ 147 KPH
should i get a professional to do this? is it a hard job ?
no, easy as. (as long as you are confident. if not take to a mechanic) should take you no longer than half hour to do both sides![]()
96 EF2 Futura I6 Auto SedanSuperlows Front/Rear with Monroe GT Sport's, EL XR Front, 16" Tickford Wheels with 225/50 Wanlis
, 5% Tint, Sony Headunit/ 6 1/2" 190w Speaker's, Fram Air Filter/XR6T Snorkle, Pacemaker 4499's/Hi Flow Cat/2.5 inch Redback, 4.11's/LSD
15.37 @ 147 KPH
so is it just a matter of undoing the bolt, pulling the bar off and putting new replacment rubbers in? then just do the bolts back up ?
its a long thread with 2 nuts, one on top and one below.
just make sure you put all the , washers,dish-washers and bushes back in there correct postion.![]()
96 EF2 Futura I6 Auto SedanSuperlows Front/Rear with Monroe GT Sport's, EL XR Front, 16" Tickford Wheels with 225/50 Wanlis
, 5% Tint, Sony Headunit/ 6 1/2" 190w Speaker's, Fram Air Filter/XR6T Snorkle, Pacemaker 4499's/Hi Flow Cat/2.5 inch Redback, 4.11's/LSD
15.37 @ 147 KPH
Hi all,this is good info as i noticed my vx does the same thing. Cheers,Chris
do you have msn, i can chat to you about this on there, i have a few pics of what i think is the problem. my addy is innocentmj@hotmail.com
you are added. my username is same as here/ VT berlina 07
96 EF2 Futura I6 Auto SedanSuperlows Front/Rear with Monroe GT Sport's, EL XR Front, 16" Tickford Wheels with 225/50 Wanlis
, 5% Tint, Sony Headunit/ 6 1/2" 190w Speaker's, Fram Air Filter/XR6T Snorkle, Pacemaker 4499's/Hi Flow Cat/2.5 inch Redback, 4.11's/LSD
15.37 @ 147 KPH
this happened on my VT Acclaim had to get the steering rack replaced. cost $1500 to do.
MY RIDE
I thought I was wrong once but I was mistaken.
i hope that $1500 included a brand new pump and hoses and etc.
96 EF2 Futura I6 Auto SedanSuperlows Front/Rear with Monroe GT Sport's, EL XR Front, 16" Tickford Wheels with 225/50 Wanlis
, 5% Tint, Sony Headunit/ 6 1/2" 190w Speaker's, Fram Air Filter/XR6T Snorkle, Pacemaker 4499's/Hi Flow Cat/2.5 inch Redback, 4.11's/LSD
15.37 @ 147 KPH
yep all of that