Gidday guys, I wanna replace the long plastic part on either side of the car that runs along the floor and under the doors, sorry I don't know the name of it. Is it very hard to replace? As it looks like its all one piece.
Thanks
Couldn't be without my Commodore
its pretty easy to take out if ya know how, there is to long oval looking cover panels on the front and rear part of the panel which should pop out and there will be some star screws underneath them, there should also be a a screw near the kick panel and one at the bottom of the B pillar. hope that helps
Would it require me to remove the seats to make it easier to remove?
Couldn't be without my Commodore
Not at all
The Blue One
Ok I have located the screws but the pannels seems to be as I suspected all one long piece! I can't think of any other way to remove them without having to remove the seats! am I doing something wrong? Thanks for your help!
Couldn't be without my Commodore
You definitely dont have to remove the seats, i know cause ive got the entire pass side floor trim out to run speaker wire down that side.
The side trim on the seats has to come off, remove recliner knob & a small round cover that hides a screw, once u have removed them, theres about 2-3 clips that have to be released use a long flat blade screw driver. After this it will come off.
Now, between the side floor trim & the seat, you'll see a plastic piece that sits between the too. This is most likely wats stopping you from removed the side trim. Its held in by a few clips, which require a small flat bladed screw driver to release. Once these have come out, the other trim can be removed.
The Blue One
Ok sweet. I was having a look the other day and it looked as though it was to long to remove without taking out the seats. But if it can be done without that great deal of hassle I'm happy!
Thanks!
Couldn't be without my Commodore