VZ 05 wont cank over...ecu, bcm, sensors? PLZ HELP

[mx_chik]

Hey guys i have read through other threads on here to try sorting out my issue but each one is a little different to my situation so thought id list the specifics.

Its an 05 VZ as stated (auto), last night we went to go out for dinner and it wouldnt start. Just ticking at the stater motor no cranking. It was first claiming an ABS fault, then later, low fuel, service and SRS airbags. i have checked terminals, battery, starter wires and reset the ecu. since reseting, the ignition wont even turn on so i cant even system check to get an error. Has anyone experienced this before please help!!

[impulsive]

Dead battery... Replace it you should be fine. Ticking at the starter motors usually tells me this

[richardpalinkas]

all the faults appearing also tells a dead battery. my battery went and said abs fault a week before it died

[db_notso]

+1 dead battery
the abs module doesnt have enough voltage to wake up and so sets codes in ipc "abs fault"
light goes out if jump start if battery fault as altenator takes over the supply job of voltage

else worst case scenario intermittant no clicking and no start is earth inside ECM needing new engine control module
replace battery check if any lights on then repost here!~

[impulsive]

I can get batteries for $40