WA / Perth VZ Alloytech Tuning

[nobullneeded]

Hey All,
Finally upgraded my set of wheels to a VZ Commodore,
Have done a few small mods and am looking for somewhere to get the car tuned on a dyno. Thought i would ask the question before starting to call around

Yes I do realise that this will be in the ball park of $$1000ish

The question remains though, Who of you drive a VZ in Perth and have had it tuned, Your experiences and recommendations are welcome.

From my researching on the forums, Seems that a VCM Tuner / HP Tuner is what is needed to get into the factory ecu, Can someone confirm that?


Yes, I realise i can get more HP outa an 8 so please refrain from clogging the thread with those remarks / negativity.

[Phyco]

I notice you are SOR, and I hear Pro Auto: Your Car Service Specialists are very good so try contacting them and see what they will charge for a VCM tune (yes this is what is required for the Alloytec V6). I had mine done for around the 800-850 mark at a place in Wangara, certainly goes harder now than before they had it!

[nobullneeded]

Thanks for the reply Phyco, How ever, I dont mind traveling north if they will spend the time to do a decent job.
Do you mind me asking if you had yours dynod? / What HP @ Wheels?

[Jacko84]

Justin @ Bye Performance seems to do abit of everything, i havnt been to him but herd alot about him, i think hes in welshpool

[Vt_vic]

justin at bye does a lot of v6's and i think active do the alloytechs but im not 100 percent

[GEN3RATD]

Justin at BYE.

[nobullneeded]

Sorry Guys, Thanks for the Suggestion of BYE, But for own reasons, Will be staying away from BYE.
Other Workshops fpr suggestion are more then welcome!

[Phyco]

Thanks for the reply Phyco, How ever, I dont mind traveling north if they will spend the time to do a decent job.
Do you mind me asking if you had yours dynod? / What HP @ Wheels?

No worries. Mine was done at Pro Race Products Wangara, results here: My 06 Acclaim