JarBro
New Member
- Joined
- Nov 30, 2014
- Messages
- 32
- Reaction score
- 2
- Points
- 0
- Location
- Karratha
- Members Ride
- VZ Executive Wagon
Hi guys codes I have coming up.
P2229 Barometric pressure sensor voltage high
P0343 Intake CMP sensor circuit high voltage (bank1)
P0348 Intake CMP sensor circuit high voltage (bank2)
P0521 Oil Pressure sensor range/performance
P0118 ECT sensor circuit high voltage
P0197 Engine oil temp low voltage
I am thinking this is a possible ECU problem and probably needs replacing, can any guru's confirm this off the given codes.
As for code P0118 this keeps my fans running from the time I start up and my temp needle does not even move off cold. Now when i reset the codes for about 2 seconds the fans stop running and my temp needle begins to rise before it trips out again and goes back to faulted.
So I assume all codes are resetting but in a matter of seconds they are all faulting again. Sounds like a bad ECU but just want second opinions please.
Thanks.
P2229 Barometric pressure sensor voltage high
P0343 Intake CMP sensor circuit high voltage (bank1)
P0348 Intake CMP sensor circuit high voltage (bank2)
P0521 Oil Pressure sensor range/performance
P0118 ECT sensor circuit high voltage
P0197 Engine oil temp low voltage
I am thinking this is a possible ECU problem and probably needs replacing, can any guru's confirm this off the given codes.
As for code P0118 this keeps my fans running from the time I start up and my temp needle does not even move off cold. Now when i reset the codes for about 2 seconds the fans stop running and my temp needle begins to rise before it trips out again and goes back to faulted.
So I assume all codes are resetting but in a matter of seconds they are all faulting again. Sounds like a bad ECU but just want second opinions please.
Thanks.