Search results

I acid bathed everything TB, elbow, inlet manifold i checked it too fingers still clean lol and I cleaned the IAC when it was out, will the comp tell me if the IAC is faulty? I'm looking at getting a new IAC soon anyway (running low on funds already spent over 3.5k on the motor and bay as it is lol)

what im trying to ask is do all the sensors come up in the fault codes like the crank angle sensor, IAC, fuel pump, lines, flow do they show up if they are faulty?? i.e can anyone tell me what sensors are covered by the check engine light and what are not (if any?)

installed the new TPS, doesn't seen to splutter under load or high revs, code 44 is gone for somereason but code 22 still comes up checked it twice..

Sorry was Spose to say I bought it off eBay, so I'm just waiting for postage

okay so I got a VN series 2 engine and rebuilt it and everything in the engine bay. Everything on the engine and in the bay is brand new or remanufactured except for the Crank shaft conrods crank angle sensor tps sensor and the other sensor on the butterfly.. the two water temp sensors next...

that's what I was thinking but it seem okay.. 25 mins ago I put it up on the ramps, connected a battery to the pump with connectors ( my pump is external, sits in front of the tank) and pumped out 5L of fuel not a problem but then it started to come out with fuel and air bubbles but left it...

bit of a long story.. okay so here's what happened normal day dropped the misses off at tafe after work I went to pick her up.. on the way there is a high hill about 2-4km long I got to the top and the car started to conk out felt like I ran out of fuel.. i tried to start it again and it...

Hi I'm just wanting to hear from people that have changed the interior on their vn's With like vr-vs-vt-vx ect was it or is it all bolt straight up mainly the front and back seats I want to change in my car, but I dot want to fork over 2-300 to buy front an back seats an find out I can't use...

but back to the question what things should I replace in my new motor iv made a list so far 1 complete gasket kit from ebay coming in soon 2 welsh plugs 3 complete hose kit these are the only things I can think of but are their any barings or other stuff I should do 'In' the motor before it...

okay just had a quick look on wiki and it says this "In September 1989 the Series II of the VN Commodore was released with the EV6 motor. Some of the changes included a new cast exhaust manifold, new camshaft sprocket profile and timing chain" plus some other stuff.. well my car was march 1990...

the vin number is 6H8VNK19HLL414018 model vn8vk19-114 built MAR 90 engine LG2 I should have been a little clearer it was originally a AUTO but when I got the car the trans was buggered and after I went through three different automatic trans (not through me trashing them I was told...

Okay this is my first post and first off I just want to say all you guys are legends, iv been reading this forum for years and from all you people I have fixed, modified, repaired and saved thousands on all of my Holdens. ill try keep it short but you the full story my car is a VN S2 but...