It takes just a moment to join our fantastic community
yes, they go all brittle after a while.
Good result. ;)
Thats of cause if your replacing them [the hoses],
If your just re-sealing them,
Then there is a special tool to loosen them...
Guilty as charged your honour !,
I confess, I have an Autel
I also have a Tech2 [Clone] that I am thinking of selling,
Purchased it new...
Assuming its a VE ?
Which side ?
I bet its the Drivers side ?
Wont be a Fuse because the other windows work ok ?,
Wont be a short,
Yep, the old faulty heater tap issue, plastic and brittle,
Replace the tap and heater hoses if required,
BUT, be careful of the hoses to the...
Sounds like you May have crushed a cable or similar.
Don’t lite a cigarette!
What code was it ?, for the records.
I think most of the L67’s had Auto’s,
we’re manuals were an option.
The only easiest way, would get a Monaro L67 and Manual box combination and drop it in, I thinks classed as a CV6 ?
Otherwise you will need to...
At 300,000 k's, I would say replace it,
because will cost you a lot more to repair it, than replace it.
Maybe yours has been changed at some time...
Is it a Ex Police Car ?
If so, I read there is as switch up on the map light unit that can turn all/part of the dash lights off,
It Sounds like...
I guessing they do that as the Dizzy sockets are high.
When I worked in Workshop years ago,
I got told NEVER cross them [spark plug...
Take the screws out, as they could cause the leak past the threads, unless you have silicon or glued them in,
Were I said use a bit of Vac hose,...
The Vac tree has 2 screws in it,
for the case of the exercise, just place a bit of Vac hose on both vac tree ports
[it will go now where, but at...
Remember to turn the rear demister off, if you happen to turn it on.
As accentstencil mentioned, you need to bleed the system.
Is the water leaking out onto the ground ?,
If so, were about's, the front of the...
Goin by the image,
You have Dual Zone [system] activated, but Air-conditioning is turned off,
Press the Zone Button and it will change from "DZ"...
Get it scanned to see what caused the MIL to illuminate,
Not all DTC cause the MIL to illuminate.
Sounds like he [the mechanic] broke the spark plug while removing it, to make it look a worse than what it is,
That's an old trick I heard of back...
To confirm if a wreckers part will fit,
And if you can safely remove the part,
Take it to the wrecker [as a sample] and see if the replacement is...
The other thing I did forgot mention,
Make sure the top of the sway bar link washers are the correct way around,
And use some shake proof washers,...
Whats Wrong with your Wheels ?
and Well done ! ;)
We all like Happy Endings :D
I maybe wrong,
but I think the cores are the same across the VY Range, going by the inlet/outlet pipes,
as I have worked on our VT Series 2...
Check your manifold bolts and exhaust bolts,
Also the Bonnet Seal when the Air Vents is located,
As the smell maybe coming up through the engine...
Or a injector connector,
and a faulty ABS sensor, or a connector,
Depending on the model, I read somewhere there was a issue with the loom that...
Perfect, because it may help another JC member ;)
Sway bar links are ALWAYS a pain in the ####,
and the check the top Tower nuts,
zip them up with a rattle gun, and a deep 24mm socket.
Not being critical, but maybe correct the heading of the thread in case another member is searching for the same information in the...
I like to illustration images you provide the JC Members,
Where do you get them from ?
Would be great to have a on file.
I just had a look at my VY [Super6]
FYI, As attached Photo
Replace the IAC Valve when you do the TPS,
Also could be a simple vacuum leak,
remembering the Rubber hoses/tubing could be breaking down after...
The Regulators are usually riveted into the door frame,
If and when you do replace the window regulator,
Drill the rivets out with a 3/16 drill...
Bite the bullet, go to the Wreckers a get a S/Hand one,
I have done a few for friends and relatives over the years, as I am hobby mechanic,
The other option would be get it checked,
Not sure what you call it in NSW,
but we can get it a "RACV Check" in vic, or get your local mechanic...
Best to replace them with new ones, as they are non repairable, disposable items.
Depending upon where it is driven and how its driven, and how...
As VS 5.0 & Fu Manchu said,
I am also Meguiars user,
I have used Mothers and Auto Glim products,
But always gone back to Meguiars, just cant go...
And see if its has a service history, either by the book, and/or receipts from the owner of it being serviced.
Because not many owners...
Separate names with a comma.