It takes just a moment to join our fantastic community
The difference is the studs on the backing plate, labelled along the edge of backing plate.
Pull seat out and tighten the 4 13mm nuts that hold the rails to the seat chassis.
Try two pry bars one on each side
May have lost a wheel weight when taking wheels off.
Pulling fuse would have reset the module, being a 7.5 amp wouldn't have been the issue.
The underlay is part of the carpet, they are replaced as one.
Check the HVAC drain grommet isn't leaking fluid under your carpet. Pull off the passenger side centre console trim and look under the dash on the...
Only info I can find is min pressure at idle 10psi, at 2000rpm 20psi. Doesn't say what max pressures should be.
To access the oil pickup to change O ring only sump has to come off from memory. If the O ring wasn't sealing there would be low oil pressure all...
It needs to be done when the car is faulting or it's pointless, it's clearly an intermittent issue that can't be replicated at the dealership.
Does sound like a fuel pressure issue on startup. Would need a gauge on the fuel system when it faults to confirm.
Even on a steep angle the oil...
If it's warranty the old part must be returned to Holden for the dealership to be reimbursed.
If it's a V6 look at the smaller pipe off the...
Tech 2 isn't used on VF and shift timing is not adjustable.
Actually sounds like handbrake shoes grabbing as if they are over adjusted
Sounds like centre bearing, you need to drop exhaust and heat shield to inspect it.
They are full of ****, part is still available and is a common failure.
Not a common issue as far as I'm aware.
No LS3 bubowwwwwwwwwww
I hope you're joking.
Always use Penrite HPR15 first in my LS1 and now in my cammed 6.0.
Trans service isn't rocket science, needs for be correct fluid Dex6 or equivalent and correct level. Will generally take 4.5-5litres after a pan...
Engine bay cleaned up. Much tidier looking.
I think revhigh have no idea what they are talking about.
More orange, Fortron coolant is red.
Possibly a poor choice of cooler, some work better than others..
I think the issue is that the D panel under the front fascia used to have a gap between it and the subframe on VE which allowed airflow through to...
These aren't an issue with long idle times or overcooling.
I'm not a fan of the risk of the rad cooler failing and introducing coolant into the transmission, happens more than you'd think.
You can buy coolers with a mounted fan and temp switch all built in, works mint.
Cooling, V6 still have them.
An aftermarket patch into the obd should be able to be removed with no ill effect to the canbus itself. If the issue goes away with all...
Coolant temps are up to 105 degrees so I don't see how an air cooler would be less efficient.
You can't remove the canbus, it's what all the modules use to communicate with each other. I feel you have been bullshitted somewhat.
Only if purchased new.
Sounds to me you have an engine issue and ESP is disabled because of the engine issue which is normal. So ignored ESP ie trac/stability control as...
Changing sump haha
Yeah it's a pig under 2k being a manual but it's worth it for the feel when the cam comes on. :D
Upgraded rocker trunions, sexyyyyy[IMG]
Even tighter when we took 40 though off the heads, pistons had to have valve relief machined in.
Separate names with a comma.