It takes just a moment to join our fantastic community
they sound good, had some, sound is subjective too, now have a hybrid system, hsv headers, gts 2 1/2in midsection, free flow rears sounds great
I mentioned them early on, your lower control arm bush and castor arm, did full replacements on mine with top strut polylast from superpro, steers...
yep just trimmed them
air clear filter changed,
throttle body clean, servicing (as above vr304 comment)
i get average 12lt around town 9lt highway,...
fitted up my AP's from HSV E1 no issues, no different M/C etc, have an 06 SS VE
lowering will be stiffer ride, normal
quality shocks and springs can make a big difference from being just low and hard to low and comfortable
check his out about the radiator thickness, it mentions 40mm
i did you can just see on rhs cover the SS crew, i did it to make them really solid fit, i felt they were a bit loose without it, 10 mins to make...
Boge, Sach's are very good, had a set in sons lowered ute, have used them in my other cars too, maloo, VE ss, high tyre pressure, bush's etc and...
what are you referring too
cut the centre section from mine, put in a bit of mesh (supercheap) just made up 2 brackets to support on the outer sides, mount to coil stud and...
one part people forget on the rear end that can cause or feel like it is floating or wriggley are the cradle mounts, i put the void fillers in and...
kyb, monroe, with lovells, kings or pedders springs, i found kings a bit crashey (personal taste/feeling)
go with gas shocks, above brands, could...
is it from the front, slightly left or right
was an issue mentioned long time ago
the series one sedan up till 08 had an access panel, rhs under seat, its gooped down but you just cut goop and pop round 150mm panel, you will...
mine has it, normally they dont, aftermarket clutch etc, change gearbox oil from ATF to penrite progear will make a difference, and there is a...
doing well on that battery, will need a good run too make sure new battery fully charged
if you have the ABS/ESP fault stay on (after new fully...
how old is battery
turn key (feels like it will break)while lifting handle, this how you do it if your battery is flat, lock button will only move a fraction, alarm...
Ve doesnt have z bar, if it is out only about 10mm check your alignment, if neutral castor it will be level forward and back
alot of the alignment...
Salvage Auto should have them
post for a mate who just picked up a VE SII omega,
when you lock with the key fob do you get a light on dashboard (flashing or continuous) he...
they usually have little retainer you have to pull first
mine used to do this at 38,000klm, have used penrite progear since 50,000klm (now at 219,000klm) and it may have done it once, 3 g/box oil changes...
put key in, turn till you think it will break pull handle same time, it works
which seals, got the 4 lower door seals from holden cheaper than ebay
fuel injected car no need to pump accel, does nothing, need to scan it first
have a new head unit Kenwood DPX-5100BT
used install kit AERPRO FP8018K, APUNISW2, APKWPL
cannot get steering wheel controls to work
any ideas or...
they still have ashtrays??????????????????????:po_O:eek::)
pretty sure bolt mount size is different, ve 12mm, vf 14mm
no doesnt fit
oil pressure sensor by the oil filter housing if V6
mine is noisey with nulon and castrol, quiet with penrite, known on these engines to be like this
wreckers most likely
nuts are welded to frame/chassis should be behind seat on the side
try wreckers if you want to put original stereo in, but checkout AERPRO lots of info about stereo plugs etc
AFR's with the OTR etc, greater mass than standard position etc (i'm no tuner either :rolleyes:)
average about $1200 for oil pump
check your air inlet too, but its under the car lhs near trans tunnel/engine bay
Separate names with a comma.