It takes just a moment to join our fantastic community
Hi All, Does anyone have any advice on the PCV piping/hose setup on an LS3 dropped into an earlier model Commodore? I have my LS3 crate motor...
Cheers mate, Might get myself a new LS1 pump and then fit that. Any opinions on throttle bodies? Did you use the LS1 with an adaptor plate or swap...
My VY SS had hotdogs in the middle to a single muffler that rumbled pretty well. I never noticed any drone in the cabin myself. I am looking at...
Has anyone on here used this ProFlow GM LS Oil Cooler Adapter? I have my motor out of the car currently and looking at this adapter it really...
Cheers mate. Anything to know about swapping the balancer? You wouldn't happen to have any specific information on modifying the waterpump would...
So my LS3 has arrived to replace my (very) tired LS1. I will use the converter box for the reluctor wheel, sensors etc, and replace the throttle...
Thanks for that mate, that's pretty much what I figured. I am planning on having a sunroof put in as well so moving extra wiring around should be...
Hey all! Hoping someone can help me out, I have a VY Series 1 SS Sedan with the leather interior, and that awful looking cream headlining and...
[ATTACH] This bastard here can contribute to a loss of coolant, worth checking. I would have said head gasket problems which is what I have...
Yea it's a fair whack of cash just for a reservoir, but I've got to drop everything in the bay for a full re-spray anyway and it seems a waste to...
Yea cheers mate, finally got a chance to take a look at the car yesterday, looks like I've got the float. Should have been obvious now I think...
Hey mate, sounds like an awesome ute. Just wondering what the driving experience is like on the 20"s? Would also be keen to know what brand the...
Fair enough, I just don't love the way that the SS Spoiler has the unpainted underside. I have the R8 front bumper, and should have a Monaro...
Has anyone installed the Aeroflow Radiator overflow tank and/or power steering reservoir to their Series 1 LS1 VY? The plastic bottles on my car...
Hi All, Has anyone here put the spoiler off an R8 Clubsport Sedan (VY) onto an SS Sedan (VY)? If so did anyone have any troubles and are there...
Did anyone ever go any further with this? I have an 02 VY SS Commodore that is about to get fitted with VY HSV R8 headlights and I would like to...
Fair enough, I haven't noticed bubbles in the tank, but will take a look when I next run the car. The white smoke is pretty consistent so I'm...
V6 Ecotech or V8 LS1? Had a problem with a mechanical component of the thermostat getting 'stuck' on my Ecotech that would cause it to overheat...
Sounds like a new set of gaskets all round really. Anyone replaced the lifters in their LS1 and have recommendations for something that doesn't...
Yea fair enough, I think the heads are in need of some attention. I'm considering dropping the engine and getting the heads done, replacing the...
Would the heater tap leaking cause it to leak out of that joint? I can actually see it ooze out of the joint when running, especially on start up....
Hi everyone, I've got an 02 VY SS Sedan (GenIII LS1) that leaks a lot of coolant. I was looking over the car and found coolant leaking out the...
Hey all, in the process of pulling the LS1 from my VY SS, (288,000kms, stuffed heads and oil pump) and have got a quote for an LS3 which will work...
Cheers mate good to know, I will take a look at the VCMs. Worst case scenario there is a shop near me that can make me one to fit the engine and...
Cheers mate, I would imagine that as you say the process would be similar. Alrighty, I had figured I would probably end up running the original...
Hi All, Seen a bit of info around on this one but got some questions that I haven't seen covered elseware. The LS1 in my VY SS has kicked the...
The Daily wagon, got the full towing kit, airbagged suspension in the back to get ground clearance with heavy loads, comes with panel damage, but...
NickGNB submitted a new Showcase Item: 2004 Holden Acclaim The Daily wagon, got the full towing kit, airbagged suspension in the back to get...
VY Series I SS Commodore Sedan. Been worked before I got it, SS Inductions OTR, Throttle body, new Diff, Head Unit, some 18"s that are pretty...
NickGNB submitted a new Showcase Item: 2002 Holden Commodore VY Series I SS Commodore Sedan. Been worked before I got it, SS Inductions OTR,...
Hi All, Just after a bit of clarity, will stroker kits (408 or 427) described as LS2 Stroker kits, be compatible with a VZ L76 V8 Engine? I...
Separate names with a comma.
