Search results

The Ute a lesson in knowing when to stop......

Brand new rubbers very flexible put them in with silicon spray either side pushed them in reasonably easily . it is almost like the rubber s too fat i can adjust it so it raises level but the further you go up the tighter it gets

Hi all, Hoping someone can help I have just fitted new Bailey channel rubbers and windows wont go all the way up, I have tried everything silicon spray forcing window up to push rubbers all the way into channel has any one else had this trouble and did you find a solution Cheers Mike

Hi ,does the manual use the same speed sensor as the auto? Cheers Skullator

Hi all Have got a CV like rattle under acceleration (worse when towing) But it sounds like it is coming from around the centre bearing in the tailshaft area its a bit hard to tell is there a way to pinpoint this noise better? Cheers Skullator

Hi all , Any got any clues as to abs fault Code 21 and Code 25 Lh & Rh sensor incorrect signal Fault comes up with key on engine off and key on engine on both stationary ie not moving Cheers Skullator

do you get information displayed on dashboard?

Hi george not just you ,I use diagnostic software on heavy earthmoving equipment everyday , CAT ET Cummins cense, dddl 6.45 etc And you can figure them out by having a play, but i am having the same issues, not just you. waitng on contact from seller of unit hopefully will shed some light ...

mate get a wiring diagram ,get a test light (led for beginners) it will be the best money you can spend , start at the beginning of the circuit and follow it to the end , that way you know how it works and where it is likely to fail,(if you have multiple faults and they meet in a common place...

sorted rang dellow They look like the holes are all evenly spaced but in fact they are all slightly different so it only goes on 1 way Skullator

Hi fitting Dellow Flywheel Does anyone know how you orientate the balance portion of the flywheel? there are no guide pins to locate it in correct position Cheers Mike Fitting VX S/C V6 into HJ with T5 (I love abbrev.)

Does the clutch tha came with the t5 bolt up to the 8 bolt flywheel? If not what will i need does a dellow flywheel need to balanced? fitting vx supercharged motor to hj ute so far so good..............so far Mike

Hi Can anyone help me with some advice on fitting a t5 to a L67 I will need a flywheel who would you recommend ? does this flywheel have to be balanced? Cheers Mike (combo is going in a HJ Ute project) Cheers Mike