Search results

hi i need some advise on the wiring for a vr t5 going into a vn that was a v6

Hi mate where did you get your knock sensor wiring harness from, I need to get one

Sweet that's what I have, another question, I have a 5 speed manual gearbox out of a vr, going into the vn that was a v6 auto, how dose the wiring work or what do I have to do, I've noticed the plug or harness if different

Hi all I'm putting a 355 into my vn that had a v6 auto in it, I have a manual gearbox out of a vr, I have a vn manual loom and a 5.0L manual ecu, what else is required to make this gearbox work

Thanks mate now I've pulled it all a part I see what your saying, I'll be keeping everything from the vn and putting it on the vr k frame and I'll be using vn vp 290mm rotors. Will vr extractors fit or am I going to have to find vn Vp ones

Would the vr steering rack work in the vn, or should I swap that over as well

Thanks for your help mate I appreciate it

Thanks for that, so I need to change over the control arms etc, I found a v8 booster and a master cylinder that has an inch bore, I was going to use vt calipers and vt rotors or will they not work

hi all i need some help/advise, i have a vn with a six in it, im putting in a 355, i have a vr 5.0L kframe and suspention, the top strute plate from the vr to vn looks to be quit diffrent, what do i have to do to make the vr strutes fit, do i need to change or swap the controle arms.

I was thinking of some thing along the lines of a base tune, I also have a haltech interceptor for it as well, it also needs to be wired to the loom

Hi all just finished stroking a 304 to 355 for my vn, what memcal should I use, I'm running a mild cam, big injectors, twin throttle body

Dose anyone know anything about these setups, i have seen 3 of them now and i am looking for some information on them

Ok thanks everyone I appreciate the help, love this forum

There are so many to choose from

Any recommendations on brand

It's going in a vn, and I'm going efi twin throttle body

Hi I'm new here I'm looking for a distributor for a 355 I'm building, any suggestions

Ok thanks, I've got some from engineer place, I have another question, what would be the best distributor for a 355 non carbi setup

Do you know the torque spect

Ok thanks for your help, I appreciate it

Where did you get them from, somewhere like a nuts and bolt shop

Dose anyone know where you can buy the stock rockers from, I've been searching all day, and where to get new bridge bolts as Well

I'm still learning my way around the engine, I think they are hydronic flat tapped

Yeah sorry, it's a vs 304

I was looking for some help with the cam I have, it's a crane, the numbers on one end are 950088 D2 C2 306 (I'm 95% sure) 888 (hard to read) Vs 304

what are the torque settings for roller rockers

Great, thank heaps for that, much appreciated

The l67 heads I have, have got mace roller rockers, would they suit my vy ecotec

OK no problem, thank you for that

OK thanks, mind if I ask what the differences are

No it's not supercharged, what are the differences if you don't mind me asking

will vt l67 heads suit a vy