Search results

I used some Bosch spark plugs like 7000 kms ago, today I have changed rocker cover gasket and believe engine won’t have a long life with all that sludge that I disturbed ))

Anyway, thank you very much, guys. Found my answer here : https://forums.justcommodores.com.au/threads/pls-help-replaced-spark-plugs-vacuum-hose-trouble-for-a-c.251593/

Sorry, it’s Alloytec VZ commodore, just changed rocker cover baskets and found out one hose isn’t connected anywhere, heater tap is alright and has a different hose connected

Hi everyone! Just wondering where this hose had to be connected to and what is it? It’s located on drivers side next to right rear spark plug Thank you

I have followed the scheme above and something doesn’t seem to be right

Help please, as I’m not sure if I got a wrong relay or just didn’t do something right

So just tried to use this 4pin relay that received a while ago and still no luck... the light on the switch goes on for a half a second in the moment when blinking high beams

Supercheaps in Brisbane said they can’t clear safety codes

This is what I received from eBay seller. Does it mean I have to connect black earth from relay and black earth from switch adaptor to headlight leads? And red positive ones just to positive on battery so the circuit can get closed, or I’m wrong )

Here is my harness set Red and black cables from white adapter are currently connected to black n white and to green cable of headlight plug

Oh well, I’ll photo my relay tomorrow to show you Light bar has red and black wire that go to relay

So this is my wiring I’ve got from eBay but I have only one positive and one negative for my light bar

I ordered mine from eBay for cheap and there is no instructions, asked on eBay for instructions but no response I tried to use your diagram but apparently I have more cables: totally I have 2 positive and 2 negative cables I don’t think there is any power when car is off, because I can hear...

Hey guys! Tried to follow the diagram from 1 page and use some advises above, however I just can’t make it work properly... my current setup is shown on picture. Red and black cables from adaptor connected to green and white with black cables on healight plug. So currently I can turn my bar...