Search results

ok just replaced ecu it still wont start is the ecu just plug and play or is there some ritual you have to perform HELP

will check this tomorrow

ok sounds feasible will check tomorow

How would you pick it just luck I suppose

you are right as there is neither 13 or 14 whats the next step where can I get a scan tool that's not to dear

how come I cant get any response nothing after bridging 5/6 there are only 6 wires going to that terminal [manual gearbox perhaps]

yes fuel pressure regulator

yes fuel pressure regulator

cant fault code check ,doesn't work must be different auto to mamual

Did it again anyhow car being manual there are only 6 terminals in plug under dash unscrewed the block for acsess plugged into 5&6 and did the key twice . Nothing only normal reds but nothing flashing

ok here we go I didn't mention the ute is manualwhen I went to put the paper clip that terminal only has 6 terminals so I put clip into 5&6 nothing happens the only lights that show up are normal reds However did get passenger door open finaly

ok heres my dilemma that light doesn't come on at all now

thanks for that I have not tried either of those sugestions will try tomorrow

havent had time to do the paper clip thing should try tomorrow

did you mean fuel pressure regulator

did you mean fuel pressure regulator

thanks for your interest by all related parts I would have to say it hasn't run in 2 years it stopped 330ks from home had it brought home. okay first it had no spark so I replaced the ignition module brought a new distributer and coil fantastic had spark still no start so even though I had fuel...

passenger side door unable to open neither inner nor outer door handles seem to be connected, have managed to open window fully and have prysed the door card off enough to be able to get my hand in but cant find anything that will open door. door open now thanks

Thanks lads for your assistance i'm sure i'll get there in the end.

yes ok I can do that but at one stage my son had an eleco look at it and he said that the injectors had no pulse and that it was the ecu

I think this task is beyond me as I don't have the special tools required ie fuel pressure guage, and diagnostic thingymajig

how or where do you bridge pins 5 and 6 it has new fuel pump coil ignition module have not checked fuel pressure {my last holden was a red motor FJ]

replaced 1 blown fuse but no different

found 1 blown fuse replaced but still no start

no the light stops flashing when cranking

sorry took so long no the light stops flashing when cranking

It coughed and spluterd one day 2 years ago hasn't gone since

posted reply in wrong section my bad

Ihave not checked either fuses or relays nor found any fault codes will try that next thank you

Have replaced almost all related parts now its down to no injector pulse have spark have fuel when I turn on ignition the reds appear but the thermos fan start then when i crank the motor turns over but wont fire ,if I introduce ''start you bastard'' to the air flow it will run momentarily ,I...