Search results

Yeah I just found the thread with this being discussed. Seems like there is a big difference from one person to the next. Some get 350 while others get 500. My car runs smooth as and is whisper quiet. Only 180,000k on the clock. I would have expected to get 500km from a tank since I drive...

For the people with a VS 3.8l what kind of km's can you get with a full tank of fuel? I have always been getting around 400-420k's. Dad in his VR gets almost 100k's more on average. We both have 60litre tanks and both drive in pretty similar styles. I just replaced the plugs and leads...

I am after a turquoise LHS rear door non electric in Melborune. If you have one let me know where and how much. Cheers, Minus the astrix irocz*@optushome.com.au

I'll take the VS power Mirror Switch can you send in prepaid satchel for like $7.00 to Victoria? Send me your email so I can contact you directly. Minus the astrix irocz*@optushome.com.au

LHS Rear door in turquoise color non electric by any chance?

Do you have a VR LHS Rear door non electric turquoise color? If yes how much? Cheers, Michael

Well the cable I am looking at is probably the Cruise control and not the TV cable. Does the VR have electronic kick down?

I have done this on my Chev but the TV cable looks like a different set-up on the VR. On my chev when you pull throttle the TV cable also gets pulled out. On the VR the cable does not do anything and just gets more slack. Not sure if this is correct. I just have a suspicion that the trans is...

Thanks Adam!!! I found a loose connection on the selenoid :) and it works fine now BUT??? ......it's good to know I don't have to undo toooo many things if it happens again :)

starter motor :) 1994 VR

What I have to do to replace the:thumbsup: starter motor? I think there is not much room to pull starter motor out, someone was suggesting that I have to undo the engine mount, jack the engine up, undo 2 bolts on the starter motor and pull the starter motor out. Would someone tell me where the...

Thanks for clearing that up. One of the reasons I was after the wiring diagram so I knew what I was looking at :) The car seems to be going good no problems so far. So it might have been the fuel filter the culprit.

Hmm. The connector we tested was not round but square shape black. We also unplugged it and put the probes inside of it. Maybe the connector I should be checking is a different one?

Yeah I hear ya. The fuel filter that I pulled out was really restrictive to blow air through like I mean you really had to blow pretty damn hard to get air through the other end. The new one was pretty easy to blow through so I think it was a good move to change it. I will not install the...

I checked everything today wires hoses and they all look good. I will try the CRC and see what happens. A few issues I found today. I bought a new fuel pump and fuel filter. I decided to just change the fuel filter to see what happens. I got the bugger out and found it pretty restrictive to...

I'll check that out! The car also has a slight miss when idling where you can hear it miss. It is very faint but you can notice it. It is not at set intervals but often it will miss say every 30 seconds. Anyway to test the Oil pressure unit?

Fuel pump wiring diagram 10.2v at fuel pump connector bad? good? I think i might have a problem with the fuel pump or the circuit. Does anyone have a wiring diagram so I can check everything out and make sure all the wires are good. Also the Oil pressure switch does anyone know how to check...

awesome will check it out. thanks!

I have the 4 pin connector. What is the best way to check the o2 sensor for correct operation. I found the scanned tech book picture on the o2 sensor but I can't read it. The writing is very blurred which is bad luck. I know the workings of the 1 wire o2 sensor why the hell has the VR have a...

thanks mate!

I have searched and I cant seem to find anything:cry: Hopefully greenfoam sees the post and might help out. Knowing my luck the ADS will be for a manual VR which uses a different PCM. Keep my fingers crossed. By the way I have the XDF and BIN. I don't really need them i need the ADS to...

Tunerpro and VR commodore 3.8 V6? Okay been doing some research on this just need to double check with you guys. 1994 used the 16176424 ECM for the auto cars. I found the $11 ECU on moates fileman website (although it has some issue with the checksum. I have also found a PROM BIN...

I am hoping someone can shed some light on this. I use TunerPro for my Chev camaro. But since dad has now bought a VR Commodore v6 1994 I am kind of surprised that TunerPro works on it too. Can anyone tell me what ADS file I need to data log and also what else is needed to datalog...

Does anyone know or have a table of what the coolant sensor values should be at certain temperatures? I need to check if it is not stuffed I have the info how to check the o2 sensor, but I would really like to know how to check the CTS. Can anyone help? Car is 1994 VR V6 Also does...

well I have reduced the price on the whole car. Anyone want it for $300. For $300 you get the whole car minus the brand new alternator.

I did not get a chance to get a postage cost. But I will sell it $50 shipped. How does that sound?

PM sent will get a price on postage for you. Just regular parcel post should be the cheapest.

Car is located in Melbourne, Clayton

VK Parts or whole car for $300 Whole car at the moment 1984 6cyl carby. The guy who wanted to buy the whole car wanted it for free geez some people. Here are some parts: Bought brand new Alternator Bosch unit it has about 20hrs of use. Looks like new. Sell for $80 Headlight switch...

I sold the whole car for $300 so disregard my ad.

As for the wheels I think they are interceptor rims?? Does that sound right? They are black under the covers.

Here are some pictures from another thread. http://forums.justcommodores.com.au/showthread.php?t=37230

bluish green color.

Stock wheels they are 15". Tyre widths rear 225. front 215 or 205 Will have to double check. Rears are average fronts are great!

I have a 1984 VK that is not running because of the motor. Everything else is fine. It is a straight six carby. Car located in Melbourne Clayton. Feel free to come along and dismantle what you need. Some of the better parts are: Brand New Alternator Bosch bought for $150 it still might...

if anyone wants it email me directly or send offers. [email protected]

Melbourne clayton, carby.

Engine is stuffed it could be simple as a blown head gasket. cylinders 1 and 2 are stuffed if I remember correctly after doing a compression test. Doors have not been hit. The paint is average around the car.

Anyone interested in parts then? I might wreck it out then if no one wants the whole car?

Anyone with offers?