Search results

is it sedan??? maybe you left the boot ajar? ive done this before and its amazing how a boot light can draw that much power

pulled tb off yesterday and cleaned the whole lot including iac and tps. air filter is clean as. foo-foo valve... hmm could be onto something there haha

ok, problem that i have had for a couple of weeks now and its driving me nuts. when car is cold it runs beautiful, but once warm it runs very rough, surges etc, only under about 2000rpm, when it does it, to accelerate it hesitates a little then goes great. once at revs or full throttle its fine...

give king springs a call, thats who i used, although i went ultra lows right around. but they are always bang on the money.

i installed a 230/230 and my car started up and idled fine, just a little rough while driving round town and did not like to return to normal idle after driving. just baby it and you will be fine. mine was in a manual

it very well could be the windscreen, i worked as a windscreen fitter for over 7 yrs and came across this problem a few times. the glue tends to let go at the bottom corner where the silicone is used to seal the paneles there(firewall). when looking at it, it look lke the water needs to run up...

they can be adjusted but only very slightly. to get full adjustment you need a toe kit and camber kit.

abs hi, i have an abs fault coming up and is on constant. i have changed the module the speed sensors, all the fuses are fine. where else can i look??? the fault comes up as rear wheel speed sensor. it is a vy ss ute, no trac control. any help would be awesome!! thanks

try ebay, i have seen them cheap there. also i think you will find all u need is a 27mm deep socket if my memory serves me correct. bit fiddly but can be done as i did it a few months back

i am thinkin of putting a 6ltr manifold on my ls1, it is cammed, otr intake etc. i have got varried reports, some that that they are great and gain power others that they lose power.. has anyone else experimented with these?

ok, i can help with that completely. i spent a number of years working at obrien glass auto. what it is is the seal has deterioated on the body, very simple fix but. u need to take off your interior trim and u will see about 6 10mm nuts if i remember correctly. remove them all and the window...

yeh, i have tried to reset the fault, and everytime it comes straight back. says something about voltage??

i was once having the same problem and found that i had a loose connection in the actual loom. maybe worth a look

ok, so heres the story, while working in the engine bay a spanner fell across the positve battery yerminal and the abs unit causing quiet a spark. since then i have had a abs fault come up everytime i start the car and it stays on. i have had it scanned, and it reads r/h wheel speed sensor. i...