Search results

Its a good idea when removing the steering wheel to only back the the wheel nut off a few turns. This allows you to jiggle and pull the wheel to release it from the splines without it flying off and damaging other components.

I just put two high tensile bolts with niloc nuts through the slotted guide brackets on each side of the column. I had no column adjustment, but it got me out of trouble.

I bought my new clock spring this week from Geoff at Village Motors Holden, Redcliffe..... $121.00.... BARGAIN

it could be a relay problem too...

Should anybody find that the shaft at the end of the barrel has snapped off...the easiest and most effective way to remove it I found is to pull the switch apart at the rear of the barrel enclosure..just under the wiper stalk. Its not a terribly difficult job if you have some patience and a...

I just replaced the drivers side pretensioner in my 1999 VT Commodore last week at $170.00 . I had the code cleared, the light stayed off for about 4 days before re-appearing again. Anyone had similar experiences....or know what to look for??? This is turning into an expensive expedition!!!

After market Radiator caps a big no no One strong tip I must stress.... please do not buy after market radiator caps for your VT Commodore!!! They are built differently to the genuine article and will leak water when motor is warming up. Do yourself a favour and buy a genuine cap.... I...

Commodore Fuel disconnect tools Hi there +++++ You can buy the tool in a three pack from Bursons or Repco. They come in three different colours to indicate the different sizes. 3/8 1/4 and 1 inch. They cost $21.00 for the 3 pack. The red tool is the one you use for VT commodore fuel...