Welcome to Just Commodores, a site specifically designed for all people who share the same passion as yourself.

New Posts Contact us

Just Commodores Forum Community

It takes just a moment to join our fantastic community

Register

blower

  1. LS3_VE

    Built 416 LS3 Overheating

    Hi all In need of some help, have done a LS3 conversion which from day one has always pumped out drastically more heat the original L98 especially the trans, which I get given the mods and in general it runs like a dream except here is the issue I’m having(I mostly drive in sports auto it is my...
  2. Mork123

    SuperCharger for VE SS

    Hi all, I have a 2012 VE SS V Sedan with the following modifications from C & A Auto fashion in Melbourne. Extractors Cat’s Twin 2½” cat back O.T.R Air intake Custom dyno tune (maff) Currently making 263 rwkw according to C & A Auto fashion. I looking to get a Supercharger installed and...
  3. R

    [Ecotec] L67 supercharger rotor issue

    #Supercharger rotors flaking metal Guys anyone ever seen this before?# Ride is Supercharged 3.8 VX.# I had an overheating issue recently due to blown head gasket. As i pulled top end down, i noticed the chrome coating on blower rotors was peeling and flaking off.# All this coating was...
  4. R

    Supercharger rotors flaking metal

    Guys anyone ever seen this before? Ride is Supercharged 3.8 VX. I had an overheating issue recently due to blown head gasket. As i pulled top end down, i noticed the chrome coating on blower rotors was peeling and flaking off. All this coating was sucked all through the valves and...
  5. B

    What amperage relay do I need?

    The Hi setting on my ac fan wasn't working. I swapped the relay with the rear demister relay as they are the same part number. The Hi setting now works! Sweet. So obviously I need a new relay. It is a 4 pin siemens relay, they are all through the car but no amp rating on any of them. 40amp...
  6. A

    blow it or stoke it

    which is better stroking a 308 to a 355 or putting a blower on a stock motor? can the internals handle a blower or do I have to put in some new internals? got a fairly small budget $1500 to $2000 any ideas?
  7. JA2Z

    [Buick] Boosting up - 2 or 3 Bar MAP sensor

    Hi Guys, I'm currently running a Blower with a pulley that only gives me about 2.5psi (which actually gives me only 1.5 psi Positive Boost because without the blower the Boost/Vac reading at full throttle under full load is 2 inches Hg below 0 and with the blower on, it pushes the reading up...
  8. blindworld1

    VS Performance upgrade

    2 question Im wondering is a CRS blower is restricted to p platers also what could i add to my VS to get the most performance gain i can that your allowed to have as a p plater and how much power would this add thanx in advance!
Top