Just Commodores Forum Community

It takes just a moment to join our fantastic community

Register

1995 VR Commy Speakers

Discussion in 'Car Audio' started by Tristan Martin, Sep 23, 2018.

  1. Tristan Martin

    Tristan Martin New Member

    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    1
    Joined:
    Sep 23, 2018
    Location:
    Australia
    Members Ride:
    1995 VR Commodore Executive
    Hi all, so doing my first install on my VR Commodore.
    Have installed subwoofer and amplifier already and am planning on getting new speakers for front and rear. I found on another thread that the size is 6' but can fit 6.5'.
    What speakers will i need? Was looking online and there are Coaxial and split component.
    Which one does the VR have? Assuming its probably coaxial but just wanted to make sure before i go waste my money on the wrong type.
    Cheers!
     
    Last edited: Sep 23, 2018
  2. losh1971

    losh1971 Well-Known Member

    Messages:
    4,305
    Likes Received:
    933
    Trophy Points:
    113
    Joined:
    Jan 17, 2010
    Location:
    North Tas
    Members Ride:
    VR Ute V6
    You just want to use twin cable and run each speaker from the amp. Get decent thick cable from Jaycar. I would use 2 ways, as 3 ways tend to be a bit high and may not tuck inside the covers.
     
  3. Deuce

    Deuce Super Stock

    Messages:
    1,737
    Likes Received:
    296
    Trophy Points:
    83
    Joined:
    Feb 5, 2012
    Location:
    Meremere Dragway (as often as possible)
    Members Ride:
    '94 VR SS V8
    I've got components in the front.
    So much better having the higher tones pointed at your face rather than your feet.
    I can listen to music clearer at lower volumes.
    Just my 2c
    (Usually have vol quite low nowadays as I enjoy the exhaust note that much)
     
    losh1971 likes this.

Share This Page