Just Commodores Forum Community

It takes just a moment to join our fantastic community

Register

74mm pulley no intercooler

Discussion in 'Mace Engineering' started by MicTheGreaseMonkey, Jun 18, 2019.

  1. MicTheGreaseMonkey

    MicTheGreaseMonkey Member

    Messages:
    109
    Likes Received:
    5
    Trophy Points:
    18
    Joined:
    Mar 12, 2018
    Location:
    Melbourne
    Members Ride:
    2000 l67 commodore berlina
    Hi can i go down 2 a 74mm pulley with a stage 3 cam kit, ported blower heads & elbow without a a2a or w2a set up?
     
  2. MACE

    MACE Well-Known Member

    Messages:
    3,140
    Likes Received:
    60
    Trophy Points:
    48
    Joined:
    Mar 30, 2008
    Hi MicTheGreaseMo,

    Thank you for your enquiry.

    "can i go down 2 a 74mm pulley with a stage 3 cam kit, ported blower heads & elbow without a a2a or w2a set up?"
    The 74mm is 2.9 inches 15PSI pulley, a physically smaller pulley can only be used when the motor is intercooled, cammed and dyno tuned or has a combination of all 3.98 Octane fuel must be used when installing an aftermarket supercharger pulley.

    Without caming, you can go up to 20PSI (56.8mm) pulley with the Air to Air Intercooler kit. We also offer an INTERMEDIATE INTERCOOLER PERFORMANCE KIT allows you to drop from a 3.4 to either a 2.8inchs 16PSI or 2.7 inch 17PSI pulley, on a virtually stock car and all without the need of an expensive tune**. In addition, car idle and drivability remain unchanged even with the factory tune!

    https://www.maceengineering.com.au/epages/shop.sf/sec8fe1347d35/?ObjectID=1469589

    In your case, you have ported blower heads & elbow so a tune would be required.

    If you have any other questions, please do not hesitate to ask.

    Kind regards,
    Michael
     

Share This Page