Just Commodores Forum Community

It takes just a moment to join our fantastic community

Register

adjusting panhard rod?

Discussion in 'VR - VS Holden Commodore (1993 - 1997)' started by quiksilver1, Jul 22, 2006.

  1. quiksilver1

    quiksilver1 New Member

    Messages:
    134
    Likes Received:
    0
    Trophy Points:
    0
    Joined:
    Apr 16, 2006
    Members Ride:
    vu ss
    hi, ive done a search and couldnt find the answer i need, im lowering rear of my car just wondering to adjust panhard rod do i set the length off my orginal rod and simply bolt back on?? afterwards i know i measure the tyres from the gaurds either side and make sure equal. any advice from someone who has done this would be great! thanks.
     
  2. jack.mc

    jack.mc Nothing witty to say :(

    Messages:
    1,085
    Likes Received:
    13
    Trophy Points:
    0
    Joined:
    May 19, 2005
    Location:
    Sydney, NSW
    Members Ride:
    VN Vacationer
    I put mine on at stock length, then once everthing was done drove out the front to some flat even ground, and adjusted it there - so that the gap was the same on each side between wheel and guard. Then I got a wheel alignment, and the guy said it was perfect. :)
     
  3. quiksilver1

    quiksilver1 New Member

    Messages:
    134
    Likes Received:
    0
    Trophy Points:
    0
    Joined:
    Apr 16, 2006
    Members Ride:
    vu ss
    do i need to take the rod back off to adjust it?
     
  4. quiksilver1

    quiksilver1 New Member

    Messages:
    134
    Likes Received:
    0
    Trophy Points:
    0
    Joined:
    Apr 16, 2006
    Members Ride:
    vu ss
    roughly how far across does it need to be adjusted? looks like its about 10mm from what i can see,is this normal?
     

Share This Page