Air con Not cold after replacing the Heat Tap

[stevenbaus]

http://forums.justcommodores.com.au...-heater-tap-hose-connections-taplocation..jpg
Just found this , if this is correct then i think mine is not on correct

 

[stevenbaus]

Ok just turned it around so it looks like image above. Do i assume that having it the wrong way means buying another

I just bleed the system again and went for a drive but the air con doesnt feel colder then just having air blowing.

I will buy a new unit on monday and hopefully that fixes it

I was sure i connected as the old one was installed but looks like i didnt , feel like an idiot

 

[stevenbaus]

I think i had it right the first time, just found a diagram for vt so need to turn around

 

[BlackVXGTS]

I don't have a diagram for the VT but the VS heater tap routing should be similar. Hope this helps:

 

[stevenbaus]

ok, if that is the case then the metel part on the heater tap is on the left side (closest to the right wheel) anyone with a VT commodore, can you take a picture for me ?? or anywhere I can download the vt workshop manual where it would show

 

[BlackVXGTS]

Finally found the VT diagrams:

 

[stevenbaus]

where in the service manual did you find that pic, the other picture shows the metal part on the right side but your image shows on the left.
I am picking up a relay fuse tomorrow from holden, hoping guys in spare parts can tell me

 

[stevenbaus]

found in manual page 314 (vt workshop) the metal part of the heater tap is on the right (opposite to the vs) . So looks like I have installed correctly so can only assume it needs regassing.

cheers

 

[BlackVXGTS]

Looks like the metal part of the heater tap unit has been relocated from the LHS to the RHS on the VTs. However, the hose routing is the same.