Shaun1368
New Member
- Joined
- Jun 27, 2019
- Messages
- 1
- Reaction score
- 0
- Points
- 1
- Age
- 56
- Location
- Perth
- Members Ride
- VZ SV6 Commodore Ute
G'day All
Just wondering if anyone has removed a Alloytec crank and how they done it? I've stripped the motor down but apparently the crank bearing caps are pressed into the block. I tried a pin punch on the small gap in the bottom of the cap but it didn't work and would only work for the first and last bearing cap as there is room to swing a hammer not the central two.
Just wondering if anyone has removed a Alloytec crank and how they done it? I've stripped the motor down but apparently the crank bearing caps are pressed into the block. I tried a pin punch on the small gap in the bottom of the cap but it didn't work and would only work for the first and last bearing cap as there is room to swing a hammer not the central two.