Just Commodores Forum Community

It takes just a moment to join our fantastic community

Register

boot lid fills with water

Discussion in 'VR - VS Holden Commodore (1993 - 1997)' started by 96calais, Apr 19, 2011.

  1. 96calais

    96calais New Member

    Messages:
    184
    Likes Received:
    0
    Trophy Points:
    0
    Joined:
    Apr 8, 2011
    Location:
    maroochydore
    Members Ride:
    96 vs calais series 1
    guy's thought id ask before i bother to dismantle for an inspection, after it rain's water sits in the boot lid and upon opening it leaks onto the carpet. keen to fix it! not a fan of future rust that's for sure. and the car is a very nice example. thanks for any insight
     
  2. dirt drifter

    dirt drifter white trash hillbillie

    Messages:
    523
    Likes Received:
    1
    Trophy Points:
    18
    Joined:
    Apr 19, 2009
    Location:
    massive hole in the ground
    Members Ride:
    VS 5L M6 VS 6L M6
    its most likely the taillight seals gone, the ones for the lights in the bootlid itself. i've had 2 vr-vs's do it. new seals fixed it every time
     
  3. Adds_05

    Adds_05 Member

    Messages:
    663
    Likes Received:
    3
    Trophy Points:
    18
    Joined:
    Jan 27, 2010
    Location:
    Central Coast, NSW
    Members Ride:
    VT SS 5.7L
    on the boot lid itself,down the very bottom of it which when closed sits just above the bumper,on the inside of the lid,there is meant to be a hole on either end but it is usually covered by either paint or plastic/tape. once they are opened up,the water can then drain out...
     
  4. 96calais

    96calais New Member

    Messages:
    184
    Likes Received:
    0
    Trophy Points:
    0
    Joined:
    Apr 8, 2011
    Location:
    maroochydore
    Members Ride:
    96 vs calais series 1
    just finished reading every thread like this one, so with that knowledge and the help from you guy's ill have no prob's fixing it. ill check the spare wheel boot well while i'm at it. thanks very much champion's.
     
  5. justbad4you

    justbad4you IF YOR NOT A HOLDEN

    Messages:
    1,669
    Likes Received:
    19
    Trophy Points:
    0
    Joined:
    Sep 29, 2005
    Location:
    MELBOURNE S/E BAYSIDE
    Members Ride:
    97 VT BERLINA/ 98 VS SIII MALOO (RED) LX SLR5000
    your more than welcome.good luck
     
  6. dirt drifter

    dirt drifter white trash hillbillie

    Messages:
    523
    Likes Received:
    1
    Trophy Points:
    18
    Joined:
    Apr 19, 2009
    Location:
    massive hole in the ground
    Members Ride:
    VS 5L M6 VS 6L M6
    i didnt have time to type this yesterday arvo. just in case u didn't find my post in another thread.

    last time i went into holden to get the taillight seals they only had them for one side (other side is obsolete already) get 2 of them. they have a sticky backing on one side.

    the side the seal is meant for will stick to the taillight, for the other side just flip the seal over and stick it to the bootlid, hopefully there is a witness mark on there from the old seal, line up with that and ya should get it where it wants to be.

    lets hope both side seals arent obsolete by now, or that rare spares makes them!
     

Share This Page