VY Tonner V6: Cruise won't activate, it enables but won't activate. Brake lights don't work, globes are fine. Any common causes?? I checked a couple of fuses, the obvious ones are OK. Sam
Do you have a tow bar? disconnect it, and re check ALL fuses. Some problems electrically, have occured, from the tow bar plug being connected. Usually, its the tail lights, and dash lights not working (same fuse link) Simon
Really?? hmm. Yes there's a towbar but what do you want me to disconnect?? Trailer's off and the plug's out, if that's what you mean.. Dash lights work fine, so do the taillights, only brake lights and cruise have failed. Sam
re check all your fuses, but yeah my fuse blew countless times, loosing tail lights, and dash lights. ended up being the trailer plug. I disconnected the trailer plug to the loom plug, and it stopped. Id check all fuses first bro. look on your fuse panel label, and find out which fuse matches your blown items.
after you press the cruise button you need to twist the switch up or down to enable cruise control (i think)
No, it's on the cards though as these ****ty taillights keep dropping globes. Sure do, that's the bit that isn't working. Had the car for years, know how cruise control works but thanks anyway mate. I've checked the cruise control and brake light fuses under the column there, nothing. I'll go through every fuse tomorrow. Sam
What about the cruise cancel switch and brake light swithch on the pedal. It sorta sounds to me like the plug has come off that swithch.
Just to clear this up, it was the blown brake light globes. Apparently if BOTH globes are blown, cruise control will still ENABLE, but will not ACTIVATE. Lesson learned Sam
i had the brake light problem on my VP man i just bought new sockets which then makes it work a treat
