Hey I have put the wiring colours in the attached word file. Sorry for the quality but it was a bit of a rush job.
The connectors you need are aerpro 711736 & 711398T. I ordered them from
www.gimmecarparts.com.au
These plug straight in to the new switches so just solder the wires onto your car matching the pinouts with the colours shown in the doc. The only one I haven't supplied you with is the cruise control as I cant find a connector to fit it so I just cut the plug off and used a narva 4way connector instead. I cant find the wiring diagram I had for the cruise but its easy to figure out with a multimeter anyway. I would recommend checking it on the bench before you plug it in to make sure the wiring is correct. It should be as I followed this diagram on my car and no problems. I actually got it out of a friends series 2 VX for the wiper switch because I couldnt figure it out with a multimeter. The indicator is easy to guess with a multimeter but following this diagram should work.
By the way - I accept no responsibility for anyone stuffing this up!!! :bop:
View attachment WiperIndicatorVX.doc
Hope this helps you out. The series two switches are heaps better than the series one - even the better half commented on how much smoother they work than the old ones. Although the old ones might have been a bit worn or something.
Ask me if you have any other questions I will see if I can help.
Thanks