Welcome to Just Commodores, a site specifically designed for all people who share the same passion as yourself.

New Posts Contact us

Just Commodores Forum Community

It takes just a moment to join our fantastic community

Register

Engine light after manual conversion (Searched other posts before hand)

melly

New Member
Joined
May 3, 2009
Messages
3
Reaction score
0
Points
0
Members Ride
VT Commodore
Hey i converted my daily 3.8 vt from auto manual a few months ago with a getrag 5 speed gearbox. Everything works fine just the engine light stays on now i got my holidays i want to fix it.

Looked up the fault code #24 vechial speed sensor no signial.
Now im not familiar with commodores but i thought the speedo went through the ecu into D5 (tan wire) and C6 (blue/white wire), my speedo works so is that not ur speed sensor signal as it goes through your ecu? or can some one tell me where it goes into the ecu.

Wiring diagram below auto vt
http://www.memcals.com/rcc_info_wiring.html
 
Last edited:

Claudy

French Com
Joined
May 12, 2006
Messages
450
Reaction score
3
Points
18
Age
34
Location
Perth, Two Rocks
Members Ride
Manual Gen3 VT SS + V6 VT manual turbo
Hey man, memcal is a chip that u put in the ecu itself. If ur speedo is workin then I would say it is definitely the memcal that needs to be changed to a manual one so that the light will go out. There's a bloke on eBay that sells vr/vs auto to manual wiring conversion, I know urs is vt, but msg him and he should be able to make u just a memcal for ur vt. I got mine off him
 

showbags

SENIOR EL'BAGO
Joined
Dec 7, 2009
Messages
1,898
Reaction score
28
Points
48
Location
geelong
Members Ride
VT Calais, BMW 135 m sport
you need to use a computer and bcm from a manual car as well
 
Top