FAST102 manifold on an LS2.

[Surfwagon]

bought a cable and its a much neater look.

I should have asked before if you did buy it where did you get it from.
My wiring to the Map sensor only just makes it now with the wiring stretched to the limit and passing under and along the inside of the fuel rail, would like to put it back where it should be and should I remove the manifold when and if I sell the car could easily revert back to std.

 

[Munz]

I called VCM in Melbourne and they told me it was cheaper (no postage) to buy from Powertorque as they are one of their stockists

Just check their website and see which dealer is closest to you, most should have the stock, the harness was $50 from memory

Dealer Locator

 

[Surfwagon]

thanks for the info will check it out.

 

[cpbait]

Wish i had of looked into this before i did mine, would've been cheaper than breaking two map sensors cause of the limited space.

 

[Surfwagon]

Wish i had of looked into this before i did mine, would've been cheaper than breaking two map sensors cause of the limited space.

Did you end up leaving the map sensors on the rear of move it to the front?

 

[cpbait]

Left it on the rear cause i'd already drilled the hole at the back, although i could seal it up with a good sealant and do the extension and move the sensor up front.
Should be the same for the ls1 yeah as the ls2?