deano198o
New Member
- Joined
- Feb 13, 2022
- Messages
- 3
- Reaction score
- 0
- Points
- 1
- Age
- 43
- Location
- Gold Coast
- Members Ride
- 2013 VE SS Z Series 2
Wondering if anyone can help?
I have scored a set of HSV Binnacle gauges from an E2 or 3 and am planning to put in my 2013 SS Z series ute. I am just a bit unclear or confused about the wiring requirements so they work properly. I have come across various info around the Binnacle setups. Just wondering if anyone out there might be able to help clear up some confusion.
My understanding is that the oil pressure and temp gauges wont work a non HSV series 1 VE as the sensor wont provide the signal, but sensor in series 2 will (which is fine as mine is series 2) Does anyone know if that is correct?
Also, that the below picture "HSV VE E1 E2 E3 HSV Triple Binnacle Gauge Module To Vehicle Wiring Harness Loom" is only required for series 1 non HSV VE's?
And that i could connect/spline in my gauges to the various parts of the car directly with the below pre made harness below without the need to the above module?
If anyone has done this before and could help me understand better would be appreciated
Cheers all
I have scored a set of HSV Binnacle gauges from an E2 or 3 and am planning to put in my 2013 SS Z series ute. I am just a bit unclear or confused about the wiring requirements so they work properly. I have come across various info around the Binnacle setups. Just wondering if anyone out there might be able to help clear up some confusion.
My understanding is that the oil pressure and temp gauges wont work a non HSV series 1 VE as the sensor wont provide the signal, but sensor in series 2 will (which is fine as mine is series 2) Does anyone know if that is correct?
Also, that the below picture "HSV VE E1 E2 E3 HSV Triple Binnacle Gauge Module To Vehicle Wiring Harness Loom" is only required for series 1 non HSV VE's?
And that i could connect/spline in my gauges to the various parts of the car directly with the below pre made harness below without the need to the above module?
If anyone has done this before and could help me understand better would be appreciated
Cheers all