High Pressure P/s Hose

[JSTPOZN]

Hey...


Anybody know the right way to get the new one back in...

The old 1 you dont have to worry about bending it or anything but the new one is a bitch to do..

It took many many hours to get my rounded bolt of the old one and now all the **** is of the car and i cant seem to get it back on..


Any info at this point will be great.. or even a ice cold beer.


Cheers

jstpozn:thumbsup:

 

[4PLAYN]

1. Make sure the old hose is out showing you the thread at both ends of where you unbolted it from.
2. Line up the new hose.
3. Screw in the new hose finger tight both ends.
4. Go to the wall of spanners and grab the right sized spanner.
5. Tighten up with the spanner making sure you dont overtighten and round it.
6. Fill up with power steering fluid ....
7. Put the extractor pipe back on

Somewhere within those 7 points you might have to change the O-rings on the new hose ..

Cheers

Adam :thumbsup:

 

[JSTPOZN]

Fair Wrong..

Good Luck Trying to Get the piping in both holes and inbetween all the other hoses that have to be on there before that...

 

[4PLAYN]

Dan these are the two pictures you wanted .... hope this helps
Cheers

Adam :thumbsup: