Just Commodores Forum Community

It takes just a moment to join our fantastic community

Register

hoist lifting points on a vs

Discussion in 'VR - VS Holden Commodore (1993 - 1997)' started by baroofy, Apr 11, 2009.

  1. baroofy

    baroofy New Member

    Messages:
    22
    Likes Received:
    0
    Trophy Points:
    1
    Joined:
    Feb 21, 2009
    Members Ride:
    vs equip
    i have just bought a vs series2 equipe. i was looking under the car to see where the lifting points are located so i can lift it on my hoist. i had no problem with the front points, but the location of the rear was confusing. the left rear side was ok, but the right side had some steel tubing, where i thought the hoist pad should go.
    there is a small cross beem on either side with a tie down lug welded to it. do you just cut off the lugs and lift the rear of the car here?
    i would appreciate any advice
    thanks
     
  2. hako

    hako Donating Member

    Messages:
    8,019
    Likes Received:
    75
    Trophy Points:
    48
    Joined:
    Aug 1, 2004
    Location:
    Toowoomba SE QLD
    Members Ride:
    VS11 BT1 V6
    Trolley jack locations should be the same as a hoist so I've attached a scan showing locations for the pads. Good Luck.
     

    Attached Files:

Share This Page