Injector clip

[PlenumBiscuit]

I gotta get the clip off and put it on the new injector I bet Holden have a special tool to do it

How would u go about it gently...see pics...

(I haven't attempted it yet but it's on tight)

 

[krusing]

I would say it should just slide off,
give it a spray with WD40,
and see if you can wiggle off from side to side with a pair of pliers with a piece of cloth in between the jaws..

 

[Thorby]

I gotta get the clip off and put it on the new injector I bet Holden have a special tool to do it

How would u go about it gently...see pics...

(I haven't attempted it yet but it's on tight)

You can get the removal tool from Supercheap doesn't cost much coin from memory.

 

[PlenumBiscuit]

You mean like one of these type of tools

The jacket bracket that holds the injector onto the rail probs needs one of these to widen it a part

 

[PlenumBiscuit]

I'll probably clamp the clip in a vice then lever the injector away even to pop it out

Also my injector holes are all open on the engine whilst the rail is off, what should I block them all up with

(Injured at the moment can't install injectors until am better/mobile)

 

[krusing]

I'll probably clamp the clip in a vice then lever the injector away even to pop it out

Also my injector holes are all open on the engine whilst the rail is off, what should I block them all up with

(Injured at the moment can't install injectors until am better/mobile)

Lay a cloth or something over them,
and press it down to cover the area in question.
Best to safe than sorry.