tezza
New Member
Hi everyone,
So there seems to be a little bit of a water leak coming from one of the front inlet manifold bolt holes, so looks as though it needs changing.
Ive had a look through the How to on the VR change and also have the Gregory's manual so I shouldnt have any issues with changing the gasket.
Just have a few questions:
- what size are the inlet manifold bolts (3/8")?
- can the inlet and maifold be taken off as one or is it too difficult to get at the inlet manifold bolts with the plenum and throttle body on
- should locktite be used on the inlet manifold bolts?
- does sealant (and what type) need to be applied on the gaskets and end gasket?
Thanks
So there seems to be a little bit of a water leak coming from one of the front inlet manifold bolt holes, so looks as though it needs changing.
Ive had a look through the How to on the VR change and also have the Gregory's manual so I shouldnt have any issues with changing the gasket.
Just have a few questions:
- what size are the inlet manifold bolts (3/8")?
- can the inlet and maifold be taken off as one or is it too difficult to get at the inlet manifold bolts with the plenum and throttle body on
- should locktite be used on the inlet manifold bolts?
- does sealant (and what type) need to be applied on the gaskets and end gasket?
Thanks