Jesterarts
Your freedom ends where mine begins
- Joined
- Nov 22, 2005
- Messages
- 3,817
- Reaction score
- 105
- Points
- 48
- Age
- 38
- Location
- Victoria
- Members Ride
- 2010 Nissan X-Trail ST-L
Hey people,
Just got a request for info about how i installed my front mesh so i figured i would just post a thread on it.
STUFF:
Mesh, 8 screws, 8 washers, 8 nuts (hehe) 4 toggle switch mounts from super cheap and plastic gule
STEP 1:
remove front bar, three screws at the top middle of the bar near the bonnet latch and a couple in each guard.
STEP 2:
Clean the surfaces you will be gluing to with metho
STEP 3:
Glue the toggle brackets to the front bar, let the glue fully dry (Over night) before attaching the mesh
STEP 4:
Attach the mesh using screws that fit the toggle mount holes and large washers.
STEP 5:
Replace front bar.
Just got a request for info about how i installed my front mesh so i figured i would just post a thread on it.
STUFF:
Mesh, 8 screws, 8 washers, 8 nuts (hehe) 4 toggle switch mounts from super cheap and plastic gule
STEP 1:
remove front bar, three screws at the top middle of the bar near the bonnet latch and a couple in each guard.
STEP 2:
Clean the surfaces you will be gluing to with metho
STEP 3:
Glue the toggle brackets to the front bar, let the glue fully dry (Over night) before attaching the mesh
STEP 4:
Attach the mesh using screws that fit the toggle mount holes and large washers.
STEP 5:
Replace front bar.
Last edited: