Just Commodores Forum Community

It takes just a moment to join our fantastic community

Register

L67 Wiring Harness Issue

Discussion in 'VT - VX Holden Commodore (1997 - 2002)' started by DeathSammich, Dec 9, 2017.

  1. DeathSammich

    DeathSammich Member

    Messages:
    97
    Likes Received:
    1
    Trophy Points:
    8
    Joined:
    Jun 27, 2017
    Location:
    Hobart, Tasmania
    Members Ride:
    VT Berlina S1
    L67 has been put together but won't crnak at all. I ran a wire on the starter motor and it tries to crank so it isn't faulty. I used a statement harness I believe and the engine is a VX l67 and it's in a VT series 1. I'm using the VT ecu and BCM with the Ecotec Memcal that was in it just to make sure it isn't a security issue. The light above the MODE button turns off when you turn the key but again it refuses to crank. I've got no idea what to do. Do I need to just use my VT Ecotec harness?
     
  2. immortality

    immortality Home of the smoky breakfast Bacon! Staff Member

    Messages:
    14,373
    Likes Received:
    2,337
    Trophy Points:
    113
    Joined:
    Apr 15, 2006
    Location:
    Sth Auck, NZ
    Members Ride:
    HSV VS Senator, VX s2 Calais S/C
    have you turned the engine over by hand to ensure it is turning freely?

    Made sure the battery is charged and you have good positive and earth connections on the block and starter respectively?
     
  3. DeathSammich

    DeathSammich Member

    Messages:
    97
    Likes Received:
    1
    Trophy Points:
    8
    Joined:
    Jun 27, 2017
    Location:
    Hobart, Tasmania
    Members Ride:
    VT Berlina S1
    Found out the issue is you cant use the harness on a VT series 1.
     

Share This Page