voodoo VT
New Member
- Joined
- May 4, 2009
- Messages
- 38
- Reaction score
- 0
- Points
- 0
- Location
- Gold Coast
- Members Ride
- VT Executive
Mixed info on Ecotec to L67 computers.
I have just fitted an L67 into my VT. Engine Gear-box, Wiring-loom all from a wrecking super-6 VT. Witch I stripped myself and fitted (car was running before I started)
I have both computers, and have been told a few things.
1, Once the computer is disconnected it will need to be re programmed.
2, The standard computer can be used with the super-6 chip to save reprogramming, ( so how on earth do you change the looms with out disconnecting the computer? Or dose this only work with running the standard loom onto the L67?
3, The standard computer will have a memory that will register once reconnected with the super-6 loom and chip.
Everything is fully fitted besides the radiator witch will be fitted in the morning.
The car has power with the ignition on the fuel pump will prime-up but when turned to the starter there is no life. I would have thought the fuel pump would have to run off the computer with the engine not on its own power?
Dose this mean the car need programming? I am trying to start with the standard computer and chip at this stage just to see if she will work.
I have just fitted an L67 into my VT. Engine Gear-box, Wiring-loom all from a wrecking super-6 VT. Witch I stripped myself and fitted (car was running before I started)
I have both computers, and have been told a few things.
1, Once the computer is disconnected it will need to be re programmed.
2, The standard computer can be used with the super-6 chip to save reprogramming, ( so how on earth do you change the looms with out disconnecting the computer? Or dose this only work with running the standard loom onto the L67?
3, The standard computer will have a memory that will register once reconnected with the super-6 loom and chip.
Everything is fully fitted besides the radiator witch will be fitted in the morning.
The car has power with the ignition on the fuel pump will prime-up but when turned to the starter there is no life. I would have thought the fuel pump would have to run off the computer with the engine not on its own power?
Dose this mean the car need programming? I am trying to start with the standard computer and chip at this stage just to see if she will work.