Goon
Scientific Tuning
- Joined
- Feb 20, 2006
- Messages
- 2,508
- Reaction score
- 9
- Points
- 38
- Location
- BrisVegas. QLD
- Members Ride
- VY CUSTOM.
Hey All
I'm rebuilding my carby in the next day or so, is there anything i should remember before starting her after its installed? eg. fuel flow wise, not carby build tips.
Exhaust - Is it legal to put a highflow cat on old school commies no emissions laws against it?
Exhaust Setup - 2inch end pipe on extractors, "maybe cat" followed by a 2.5 for the mid section onto a 1.5 after the diff, is this setup okay? should sound alright?
A question for 202 owners with an eco gauge, whats the perfect timing that is notice able on the eco gauge, idleing at cruise in N ? I can get the timing right, its more a matter of the good tune up.
[EDIT] - Timing - engine fires with 1st cylinder compression up? or down?
Extravtors - would these boost my original idle rpm by 1 mark? or idle should be the same as it was with an exhausthead? .
Is there a place i can get the exhaust rubber thats mounted about the rubbers before the diff, on the underbody.. its a pain hearing it rattle on the underbody. < -- not really worried about this one as it may go away after i replace the exhaust with the above setup.
Please no negative comments.
I'm rebuilding my carby in the next day or so, is there anything i should remember before starting her after its installed? eg. fuel flow wise, not carby build tips.
Exhaust - Is it legal to put a highflow cat on old school commies no emissions laws against it?
Exhaust Setup - 2inch end pipe on extractors, "maybe cat" followed by a 2.5 for the mid section onto a 1.5 after the diff, is this setup okay? should sound alright?
A question for 202 owners with an eco gauge, whats the perfect timing that is notice able on the eco gauge, idleing at cruise in N ? I can get the timing right, its more a matter of the good tune up.
[EDIT] - Timing - engine fires with 1st cylinder compression up? or down?
Extravtors - would these boost my original idle rpm by 1 mark? or idle should be the same as it was with an exhausthead? .
Is there a place i can get the exhaust rubber thats mounted about the rubbers before the diff, on the underbody.. its a pain hearing it rattle on the underbody. < -- not really worried about this one as it may go away after i replace the exhaust with the above setup.
Please no negative comments.
Last edited: