My VY Acclaim SerII

[FAT.36L]

Nice Trick With The Popper You Should Keep That On The BAck Doors And Make The Front 1's Button

SHAVED COMMODORES FTW!!!!

 

[rch-13z]

nice work mate! haven't been in here in a couple of weeks and what happens!

Sweet to see it finished

 

[FAT.36L]

Can You Take A Pic Of Inside The Door And The Way You Bent Your Wire For The Popper
Cheers

 

[Zeussy]

Cheers guys, thanks for the comments!

LOL rch-13z, I wasnt going to do much to it, then reading yours and FAT.36L's, and all the other guys 'My Ride' threads on here got me keen again..

It could be a while before it gets done, if the weather keeps up, arrrgghh...

I'll get some pics up for you FAT.36L tomorrow, I just used the bar that went to the door handle - where it goes into the lock, and extended it with a bit of round bar, pretty much straight, just where the stock one had a bend, kinda hard to explain, but will get the pics to show you, I need to pull it out to paint it gloss black anyway, its satin atm, but looks crap with bog dust all over it - sort of like a chalk board? lol

Probly just keep the manual 'poppers' for the moment = lack of funds, lol, but will look into the electronic ones,



What does every one reckon, get rid of the lower strip? where the door molds go/used to go?? fill them in??

 

[Zeussy]

Can You Take A Pic Of Inside The Door And The Way You Bent Your Wire For The Popper
Cheers

Heres a couple of pics for you FAT.36L,

They're a bit suss, but you can sorta see whats going on,

The hole through the rear quater window support, drilled from the top with the glass still in place - very slowly and carefully!! where the weld is it sort of bends away from the camera, for about two inches or so,

You can sort of see the bend there, I put a cable tie on the end of the stock piece - to stop it from pulling upwards and falling down inside the door, it could be a pain when the door trims back on... lol,

 

[Zeussy]

And heres todays efforts!
That bloody front door - buckeled before I even got the welder near it!! lol,

Kinda got the looks of a patchwork quilt coming along nicely, lol, cant wait to get these flutes, have a look what needs to be done to get them in...

Doner door, LMAO... been sitting around the side for bloody ages, good to see its going to good use eyy!!

 

[DUK13Y]

She's coming along nicely. It's always good to have some know how rather than taking it to a shop each time and forking over an arm and a leg.

 

[Zeussy]

Yepp for sure hey, a while ago I rang up a shop, that specialises in these sort of mods, and they wanted like 500-700 bucks, unpainted, lol, this didnt cost me anything so far, just need to look into the paint side of things...

 

[Zeussy]

Got my VZ SS Flutes in the mail today..

But they are plastic?? are they all normally plastic? I suppose they would be? what else would they be made out of?!! lol, not really sure what I was expecting!

I Spy With My Little Eye... A little VH, that desperately needs to be worked on :/

Complete with looms, and flashers...
Now I just need to rip off one of my gaurds.... is it illegal to drive around without one on for a day of two?!!

 

[DUK13Y]

Finally got the flutes. I think the police may consider your car to be unroadworthy without a guard. Pull an all nighter over a w/e and should be all good :thumbsup: