Just Commodores Forum Community

It takes just a moment to join our fantastic community

Register

removing headlight

Discussion in 'VL Holden Commodore (1986 - 1988)' started by harry3, Jan 25, 2010.

  1. harry3

    harry3 New Member

    Messages:
    928
    Likes Received:
    7
    Trophy Points:
    0
    Joined:
    Jul 23, 2005
    Location:
    melbourne
    Members Ride:
    vl berlina wagon 6cyl
    seems you have to remove part of front bumper top trim to get at headlight bottom screws

    can this be done without removing front bumper bar?
     
  2. harry3

    harry3 New Member

    Messages:
    928
    Likes Received:
    7
    Trophy Points:
    0
    Joined:
    Jul 23, 2005
    Location:
    melbourne
    Members Ride:
    vl berlina wagon 6cyl
    replacing bumper top trims

    can anything be used to replace the bumper bar top trims on front and rear, the original plastic ones usually fall apart due to sun damage and the VL looks untidy without them

    has anyone found a substitute?
     
  3. VL Berlina 5speed

    VL Berlina 5speed Apprentice Panel Pusher

    Messages:
    2,684
    Likes Received:
    29
    Trophy Points:
    0
    Joined:
    Oct 3, 2005
    Location:
    Adelaide
    Members Ride:
    Project VL Show car, VS Exec, VY Ute, YZ250F
    it can be done if your not too worried about your paint and what not
    i use to remove only my top centre mould and grill before to get my lights out

    but now i take it off properly with my car,
    bar off first
    sides moulds
    grill then centre
    depends if your parinoid :p

    you can get aftermarket moulds, the TYC are a good make of non genuine stuff. just make sure your happy with the product before you get it painted
     

Share This Page